EDITING
35
Tape Dubbing
CONNECT EQUIPMENT
Following the illustration on the left, connect the
1camcorder and the VCR. If you have a Remote
PAUSE terminal, use the editing cable to connect it
to the camcorder and the VCR. (See ONOTES� below
PLAY/PAUSEfor details.)
EDIT
PREPARE FOR DUBBING
Set the camcorderOs power switch to PLAY, turn on
2the VCROs power, and insert the appropriate
cassettes in the camcorder and the VCR.
SELECT VCR MODE
Engage the VCROs AUX and Record-Pause modes.
3
FIND EDIT-IN POINT
Power switch
Engage the camcorderOs Play mode to find a spot
To EDITTo AUDIO out4just before the edit-in point. Once itOs reached, press
To VIDEO outPAUSE on the camcorder.
START EDITING
Editing cableAudio and VideoPress PLAY on the camcorder and engage the VCROs
(optional 3.5 żcable (optional)5Record mode.
mini-plug cable)
STOP EDITING TEMPORARILY
Engage the VCROs Record-Pause mode and press
6PAUSE on the camcorder.
To RemoteTo AUDIO IN
EDIT MORE SEGMENTS
PAUSETo VIDEO IN
Repeat steps 4 through 6 for additional editing, then
7stop the VCR and camcorder when finished.
VCR (Recording deck)NOTES:
cWhen using a Remote PAUSE terminal, pressing EDIT
on the camcorder in step 5 automatically engages the
VCROs Record mode.
cWhen using a Remote PAUSE terminal, you can access
a function called Master Edit Control System. Before
beginning, reset the camcorderOs counter to
OM0:00:00� at an edit-out point. When the tape
reaches this point (remember thereOs a small margin of
error) during editing, the camcorder and VCR pause
automatically. However, some VCRs are not compat-
ible with the Master Edit Control System. |
ACEC
