TH-A9
CN1
Removing the analog boardAnalog board
CN401Tuner assembly
(See Figs.12 to 14)Analog board
Prior to performing the following procedure, remove
the left and right side covers.
Also remove the DVD door.
Also remove the front panel assembly and DVD
I
mechanism base.
1. Disconnect the card wires from the connectors
Engaging
CN401 and CN402 on the analog board.
point (b)
2. Remove the screw (I) that retains the analog board
bracket from the top of the unit.
Analog board
CN402Analog board bracket
3. Remove the screw (J) and the screw (K) that retain
the analog board from the rear panel of the unit.Fig.12
4. Disengage the analog board bracket and the gear
Analog board bracket
motor assembly by moving the engaged part (b)
upward. Then move the analog board in the direction Tuner assembly
CN1CN402
of the arrow, and remove it as if pulling it out of the Engaging point (b)
rear panel.
5. Remove two screws (L) that attach the analog board
to the analog board bracket.
K J
Analog board
M
CN401
Removing the tuner assemblyFig.13
(See Figs.12 and 13)
Analog board
Prior to performing the following procedure, remove
the left and right side covers.
Also remove the DVD door.
Also remove the front panel assembly and the DVD L
mechanism base.
1. Remove the three screws (M) that retain the tuner
assembly, from the rear panel of the unit.
2. Disconnect the card wire from the connector CN1 on
the tuner assembly.
Analog board bracket
L
Fig.14
1-11 |
ACEC
