EN 15
Tape remaining time indicatorSTOP RECORDING
Press the Recording Start/Stop button again to stop25MIN*- - -MIN
4recording.(Now calculating)
YThe camcorder re-enters the Record-Standby
120MINmode.
119MINNOTES:
cWhen the power switch is set to CAMERA and the LCD
monitor is opened at an angle of 45 degrees or more, the
LCD monitor switches on and the viewfinder switches3MIN
off automatically to save power.
2MIN (Blinking)cA cassette holder canOt be opened unless a power supply
is attached.
1MIN (Blinking)cThere may be a delay after you press EJECT until the
holder opens. Do not use force.
0MIN (Blinking)cThe tapeOs remaining time is displayed in the LCD
monitor or the viewfinder as shown.
cThe indicated remaining time is approximate.
cThe time required to calculate the remaining tape
length, and the accuracy of the calculation, may vary
according to the type of tape used.
cThe tape remaining time indicator is correct only if the
correct tape length has been selected (Z pg. 10).
cOTAPE END� appears when the tape reaches its end,
and the power goes off automatically if left in this
condition for 5 minutes. OTAPE END� also appears
when a cassette whose tape is already at its end is
loaded.
cWhile shooting, pressing DISPLAY lets you remove
some indications from the screen (Z pg. 47).Start/Stop button
cIf the Record�Standby mode continues for 5 minutes
without performing Zoom or any other operations, the
camcorderOs power shuts off automatically. Set the
DISPLAY buttonPower switch to OPOWER OFF�, and then back to
OCAMERA� to turn the camcorder on again.
cIf the Recording Start/Stop button is pressed after the
Record-Standby mode has continued for over 5
minutes, recording may not start immediately.
cIf youOre recording on a cassette from the middle, use
the RETAKE function (Z pg. 18) to find the end of the
last recording so you donOt erase any of it.
cThe LENS COVER warning blinks for about 10 seconds
when the camcorder is turned on when the cover is
closed.
cWhile shooting, sound is not heard from the speaker.
Tally lamp |
ACEC
