RECORDING Basic Recording (cont.)
16 EN
Shooting while watching the LCD monitor
Before the following steps, perform step 1 (Z pg. 15).
ENTER RECORD�STANDBY MODE
LENS COVER
Make sure the LCD monitor is fully open. Slide the
Switch2LENS COVER open/close switch to open the lens
cover, then set the power switch to CAMERA.
YThe power indicator lights and the camcorder
enters the Record�Standby mode.
POWERYThe scene youOre aimed at appears in the LCD
monitor, with the word OPAUSE� superimposed
Start/Stopupon it.
Power indicatorSTART SHOOTING
Tilt the LCD monitor upward/downward for best
3viewability (Z pg. 17) and press the Recording
MONITORStart/Stop button.
OPEN
YThe tally lamp lights while recording is in progress,
and OREC � appears in the LCD monitor.
STOP RECORDING
Press the Recording Start/Stop button again to stop
4recording.
YThe camcorder re-enters the Record-Standby
Tape remaining time indicatormode.
25min*- - -min
(Now calculating)NOTES:
cWhen you use the LCD monitor outdoors in direct
120minsunlight, the LCD monitor may be difficult to see. If this
happens, we recommend that you use the viewfinder
(Z pg. 15).
119min
cFor other notes, refer to pg. 15.
3min
2min (Blinking)
1min (Blinking)
0min (Blinking)
Tally lamp |
ACEC
