Master Page: Right
GR-D200US.book Page 75 Friday, April 11, 2003 1:05 PM
... make sure the memory card is positioned ... in places subject to extremely high (over 40°C
properly when inserting.or 104°F) or extremely low (under 0°C or
2. While the memory card is being accessed 32°F) temperatures.
(during recording, playback, deletion, 3. DO NOT leave the unit?
initialization, etc.)?... in places of over 50°C (122°F).
... never unload the memory card and never turn ... in places where humidity is extremely low
off the camcorder.(below 35%) or extremely high (above 80%).
3. Store memory cards?... in direct sunlight.
... away from heaters or other heat sources.... in a closed car in summer.
... out of direct sunlight.... near a heater.
... where they won?t be subject to unnecessary 4. To protect the unit, DO NOT?
shock or vibration.... allow it to become wet.
... where they won?t be exposed to strong ... drop the unit or strike it against hard objects.
magnetic fields (such as those generated by ... subject it to shock or excessive vibration
motors, transformers or magnets).during transportation.
... keep the lens directed at extremely bright
LCD Monitorobjects for long periods.
... expose the lens and viewfinder?s lens to direct
1. To prevent damage to the LCD monitor,sunlight.
DO NOT?... carry it by holding the LCD monitor or the
... push it strongly or apply any shocks.viewfinder.
... place the camcorder with the LCD monitor on ... swing it excessively when using the hand
the bottom.strap or the grip.
2. To prolong service life?... swing the soft camera case excessively when
... avoid rubbing it with coarse cloth.the camcorder is inside it.
3. Be aware of the following phenomena for LCD 5. Dirty heads can cause the following problems:
monitor use.
These are not malfunctions:
While using the camcorder, the surface around
the LCD monitor and/or the back of the LCD
monitor may heat up.
If you leave power on for a long time, the
surface around the LCD monitor becomes hot.No picture during playback.
Blocks of noise appear during playback.
During recording or playback, the Head Clog
Main UnitWarning indicator ?? appears.
1. For safety, DO NOT?Recording cannot be performed properly.
... open the camcorder?s chassis.In such cases, use an optional cleaning cassette.
... disassemble or modify the unit.Insert it and play back. If the cassette is used more
... short-circuit the terminals of the battery pack. than once consecutively, damage to the video heads
Keep it away from metallic objects when not may result. After the camcorder plays back for about
in use.20 seconds, it stops automatically. Also refer to the
... allow inflammables, water or metallic objects cleaning cassette?s instructions.
to enter the unit.If, after using the cleaning cassette, the problems still
... remove the battery pack or disconnect the exist, consult your nearest JVC dealer.REFERENCES
power supply while the power is on.Mechanical moving parts used to move the video
... leave the battery pack attached when the heads and video tape tend to become dirty and
camcorder is not in use.worn out over time. In order to maintain a clear
2. Avoid using the unit?picture at all times, periodic check-ups are
... in places subject to excessive humidity or recommended after using the unit for about 1,000
dust.hours. For periodic check-ups please consult your
... in places subject to soot or steam such as near nearest JVC dealer.
a cooking stove.
... in places subject to excessive shock or
vibration.
... near a television set.
... near appliances generating strong magnetic or
electric fields (speakers, broadcasting
antennas, etc.). |
ACEC
