SYSTEMPRIORITY
O SYSTEM� functions which are set when the Power[LCD]: When the LCD monitor is fully open, even if
Switch r is set to O � are also applied when thethe viewfinder is pulled out, the image is displayed
Power Switch r is set to OPLAY� ( pg. 24).only on the LCD monitor; it will not be displayed in the
viewfinder.
STYS EMFINDER: When the viewfinder is pulled out, even if
BEEP� MELODY
the LCD monitor is fully open, the image is displayed
TALLY� ON
REMOTE� ONonly in the viewfinder; it will not be displayed on the
DEMO MODE � ONLCD monitor.
PRIORITY � LCD
CAM RESET
CAM RESET
[RETURN]: Does not reset all settings to the
RETURNfactory-preset.
EXECUTE: Resets all settings to the factory-preset.
BEEP
CAMERA DISPLAY
OFF: Even though not heard while shooting, shutter
sound is recorded on the tape.Y Settings made in the O CAMERA DISPLAY� Menu
are effective only for video shooting.
BEEP: The beep sounds when the power is turned on
Y Settings made in the O CAMERA DISPLAY� Menu
or off, and at the beginning and end of recording. Also
remain effective even when the Power Switch r is
to activate the shutter sound effect ( pg. 18).set to O �. However, the menu settings can be
[MELODY]: Instead of a beep, a melody soundschanged only when the Power Switch r is set to
when any operation is performed. It also activates theO �.
shutter sound effect ( pg. 18).
CDAMERAISPLAY
TALLYBRIGHT
ON SCREEN �LCD/TV
OFF: The tally lamp remains off at all times.DATE/TIME �AOUT
TIME CODE �OFF
[ON]: The tally lamp comes on to signal the start ofCLOCKDEC 25 O03
recording.ADJ .5:30 PM
REMOTE
It is recommended that this function be set to OOFF�RETURN
to prevent improper operation.
DEMO MODEBRIGHT
OFF: Automatic demonstration will not take place. pg. 11, OTo Adjust The Brightness Of The Display�
[ON]: Demonstrates certain functions such asON SCREEN
Program AE with special effects, etc., and can be
LCD: Keeps the camcorderOs display (except the
used to confirm how these functions operate.
date, time and time code) from appearing on the
Demonstration starts in the following cases:
connected TV screen.
Y When the Menu Screen is closed after ODEMO
[LCD/TV]: Makes the camcorderOs display appear on
MODE� is turned OON�.
screen when the camcorder is connected to a TV.
Y With ODEMO MODE� set to OON�, if there is no
operation for about 3 minutes after the PowerDATE/TIME
Switch r is set to O � or O � .
OFF: The date/time does not appear.
Performing any operation during the demonstration
[AUTO]: Displays the date/time for approx. 5
stops the demonstration temporarily. If no operation is
seconds in the following cases:
performed for more than 3 minutes after that, the
demonstration will resume.Y When the Power Switch r is set from OOFF
(CHARGE)� to O � or O �.
NOTES:Y When tape playback starts. The camcorder displays
I If a tape is in the camcorder, the demonstration cannot bethe date/time when scenes are recorded.
turned on.Y When the date is changed during tape playback.
I ODEMO MODE� remains OON� even if the camcorderON: The date/time is always displayed.
power is turned off.
I If ODEMO MODE� remains OON�, some functions will not
be available. After viewing demo, set to OOFF�.[ ] = Factory-preset
EN
USING MENUS FOR DETAILED ADJUSTMENT23
GR-D22_16-28_EN2325/9/03, 3:31 PM |
ACEC
