MasterPage: Left
GR-D252AA_AG_AH_AS.book Page 42 Tuesday, July 19, 2005 5:55 PM
TROUBLESHOOTING42 EN
The colour of Snapshot looks strange.SET DATE/TIME!? appears.
I The light source or the subject does not include I The date/time is not set.
white. Or there are various different light sources HSet the date/time. ( pg. 14)
behind the subject.I The built-in clock battery has run out and the
HFind a white subject and compose your shot so previously set date/time has been erased.
that it also appears in the frame. ( pg. 31)HConsult your nearest JVC dealer for replacement.
The image taken using Snapshot is too When the image is printed from the printer,
dark.a black bar appears at the bottom of the
I Shooting was performed under backlit conditions.screen.
HPress BACK LIGHT. ( pg. 33)I This is not a malfunction.
HBy recording with ?DIS? activated ( pg. 24, 26)
The image taken using Snapshot is too this can be avoided.
bright.
When the camcorder is connected via the
I The subject is too bright.
DV connector, the camcorder does not
HSet ?r? to ?SPOTLIGHT?. ( pg. 36)
operate.
White Balance cannot be activated.I The DV cable was plugged/unplugged with power
I The Sepia (SEPIA) or Monotone (MONOTONE) turned on.
mode is activated.HTurn the camcorder?s power off and on again,
HDisengage the Sepia (SEPIA) or Monotone then operate it.
(MONOTONE) mode before setting White
Images on the LCD monitor appear dark or
Balance. ( pg. 36)
whitish.
The Black & White Fader does not work.
I In places subject to low temperature, images
I The Sepia (SEPIA) or Monotone (MONOTONE) become dark due to the characteristics of the
mode is activated.LCD monitor. This is not a malfunction.
HDisengage the Sepia (SEPIA) and Monotone HAdjust the brightness and angle of the LCD
(MONOTONE). ( pg. 36)monitor. ( pg. 15, 18)
I When the LCD monitor?s fluorescent light reaches
The image looks like the shutter speed is the end of its service life, images on the LCD
too slow.monitor become dark.
HConsult your nearest JVC dealer.
I When shooting in the dark, the unit becomes
highly sensitive to light when ?GAIN UP? is set to
Coloured bright spots appear all over the
?AUTO?.
LCD monitor or the viewfinder.
HIf you want the lighting to look more natural, set
?GAIN UP? to ?AGC? or ?OFF?. ( pg. 24, 25)I The LCD monitor and the viewfinder are made
with high-precision technology. However, black
Other problemsspots or bright spots of light (red, green or blue)
may appear constantly on the LCD monitor or the
The POWER/CHARGE lamp on the viewfinder. These spots are not recorded on the
camcorder does not light during charging.tape. This is not due to any defect of the unit.
(Effective dots: more than 99.99 %)
I Charging is difficult in places subject to extremely
high/low temperatures.The cassette will not load properly.
HTo protect the battery, it is recommended to
I The battery?s charge is low.
charge it in places with a temperature of 10°C to
HInstall a fully charged battery. ( pg. 11)
35°C. ( pg. 46)
I The battery pack is not attached firmly.
HDetach the battery pack once again and re-attach
it firmly. ( pg. 11) |
ACEC
