MasterPage: Left
G R-D340PAL.book Pag e 12 Thursday , October 27 , 2005 3:19 PM
GETTING STARTED12EN
How To Attach The Lens Cap
Power
To protect the lens, attach
This camcorder?s 2-way power supply system
the provided lens cap to the
lets you choose the most appropriate source of
camcorder as shown in the
power. Do not use provided power supply units
illustration.
with other equipment.
NOTE:
Charging The Battery Pack
To confirm the lens cap is on
correctly make sure the cap is
flush to the camcorder. Batterypackmount
PUSH
BATT.
Batterypack
Placehereduring
shooting.
POWER/
CHARGE
Arrow
How To Attach The Shoulder Straplamp
Follow the illustration.
1Thread the strap through the eyelet.
ToDCToAC outlet
2Fold it back and thread it through the strap connector
guide and the buckle.
I To adjust the length of the strap, loosen and then
Power
tighten the strap in the buckle.switch
3Slide the strap guide fully towards the eyelet.
BuckleACAdapter (ex.AP-V17E)
Strapguide1Set the Power Switch to ?OFF?.
2
2With the arrow on the battery pack pointing
2downward, push the battery pack slightly against
the battery pack mount a.
3Slide down the battery pack until it locks in
place b.
4Connect the AC Adapter to the camcorder.
5Connect the Power Cord to the AC Adapter.
(AP-V14E only)
6Plug the AC Adapter into an AC outlet. The
3
1POWER/CHARGE lamp on the camcorder
Eyeletblinks to indicate charging has started.
7When the POWER/CHARGE lamp goes out,
charging is finished. Unplug the AC Adapter
from the AC outlet. Disconnect the AC Adapter
from the camcorder. |