MasterPage: Left
GR-D370AH_EN.book Page 50 Monday, April 17, 2006 2:24 PM
TROUBLESHOOTING50 EN
INSERT ERROR!CARD ERROR!
<CANNOT EDIT ON A LP RECORDED Appears when the camcorder does not
TAPE>
recognise the loaded memory card. Remove the
<CHECK TAPEOS ERASE PROTECTION
memory card once and insert it again. Repeat
TAB>
these procedures until no indication appears. If
<CANNOT EDIT ON A BLANK PORTION>the indication still appears, the memory card is
IAppears if Insert Editing is attempted on a tape corrupted.
recorded in the LP mode. ( pg. 46)
IAppears if INSERT () on the remote control CHECK CARDOS WRITE PROTECTION
is pressed when the erase protection tab is set SWITCH
to OSAVE�. ( pg. 46)Appears when you attempt to shoot digital still
IAppears if Insert Editing is attempted on a images when the write protection tab on the SD
blank portion of a tape. ( pg. 46) Memory Card is set to the OLOCK� position.
MEMORY IS FULLUNIT IN SAFEGUARD MODE
Appears when the memory cardOs memory is full REMOVE AND REATTACH BATTERY OR DC
and shooting is not possible.PLUG
The error indications (01, 02 or 06) show what
HDV
type of malfunction has occured. When an error
Appears when pictures recorded in the HDV indication appears, the camcorder turns off
format are detected. The pictures in the HDV automatically. Remove the power supply
format cannot be played back with this (battery, etc.) and wait a few minutes for the
camcorder.indication to clear. When it does, you can
resume using the camcorder. If the indication
?remains, consult your nearest JVC dealer.
Appears when playing back a Ţle that is not
UNIT IN SAFEGUARD MODE
compatible with DCF or a Ţle with a size that is
EJECT AND REINSERT TAPE
not compatible with this camcorder.
The error indications (03 or 04) show what type
COPY PROTECTEDof malfunction has occured. When an error
Appears if dubbing of copyguarded signals is indication appears, the camcorder turns off
attempted while this camcorder is being used as automatically. Eject the cassette once and re-
a recorder.insert it, then check if the indication clears.
When it does, you can resume using the
MEMORY CARD!camcorder. If the indication remains, consult
your nearest JVC dealer.
Appears if there is no memory card loaded when
the SNAPSHOT Button is pressed while the
Power Switch is set to OREC� and the VIDEO/
MEMORY Switch is set to OMEMORY�.
PLEASE FORMAT
Appears when there is a problem with a memory
card and its memory is corrupt, or it has not
been initialised. Initialise the memory card.
( pg. 31)
NO IMAGES STORED
Appears if there are no image Ţles stored in the
memory card when you attempt memory card
playback. |
ACEC
