MasterPage: Left
GR-D396US.book Page 22 Friday, December 30, 2005 1:25 PM
VIDEO PLAYBACK22 EN
Shuttle SearchNOTES:
IBefore starting Blank Search, if the current
Allows high-speed search in either direction
position is at a blank portion, the camcorder
during video playback.
searches in the reverse direction. If the current
1) During playback, press ! for forward
position is at a recorded portion, the camcorder
search, or 1 for reverse search.
searches in the forward direction.
2) To resume normal playback, press 6.IIf the beginning or end of the tape is reached
IDuring playback, press and hold ! or 1. The during Blank Search, the camcorder stops
search continues as long as you hold the button.
automatically.
Once you release the button, normal playback
IA blank portion which is shorter than 5 seconds of
resumes.
tape may not be detected.
IA slight mosaic effect appears on the display IThe detected blank portion may be located
during Shuttle Search. This is not a malfunction.
between recorded scenes. Before you start
ATTENTION:recording, make sure there is no recorded scene
During Shuttle Search, parts after the blank portion.
of the picture may not be
clearly visible, particularly on
the left side of the screen.
Blank Search
Helps you Ţnd where you should start recording
in the middle of a tape to avoid time code
interruption. ( pg. 20)
1Load a cassette. ( pg. 18)
2Set the VIDEO/MEMORY Switch to OVIDEO�.
3Set the Power Switch to OPLAY� while
pressing down the Lock Button located on the
switch.
4Press BLANK.
IThe OBLANK SEARCH� indication appears and
the camcorder automatically starts reverse or
forward search, then stops at the spot which is
about 3 seconds of tape before the beginning of
the detected blank portion.
ITo cancel Blank Search, press 7 or BLANK. |
ACEC
