Basic Shooting (Snapshot)
^
You can use your camcorder as a digital still camera for
taking snapshots.
Perform the procedures listed below before continuing.
I Power ( pg. 7)4
I Grip Adjustment ( pg. 8)
I Viewfinder Adjustment ( pg. 8)
I Loading A Memory Card ( pg. 11)
I Picture Quality/Image Size Setting ( pg. 11)
1Set the VIDEO/MEMORY Switch 4 to MEMORY,
then set the Power Switch u to or while
pressing down the Lock Button y located on theyu
switch. Open the LCD monitor fully or pull out the
viewfinder fully.
2Press SNAPSHOT ^. PHOTO� y appears whileImage Size pg. 11
the snapshot is being taken.
The image is recorded on the memory card.Shooting icon pg. 50, 51
Y Still images are recorded in the snapshot mode with
Card icon pg. 50, 51
no frame.
To Delete Unwanted Still Images . . .1024
51Remaining number of shots
..... when unwanted still images are stored in the pg. 50, 51
memory card or its memory is full, refer to(Approximate Number of
Deleting Files ( pg. 20) and delete unwantedStorable Images pg. 18)
still images.
To Remove The Shutter Sound . . .
..... when you do not want to hear the shutter sound,
Display
set BEEP to OFF in the Menu ScreenPicture Quality pg. 11
( pg. 30). The sound is no longer heard from the
speaker.
NOTES:
I Even if DIS is set to ON ( pg. 29), the Stabiliser will
be disabled.
To Protect Valuable Files (available only for SD
I If Snapshot recording is not possible, PHOTO� y blinks
Memory Card) . . .
when SNAPSHOT ^ is pressed.
I If Programme AE with special effects ( pg. 23) is
engaged, certain modes of Programme AE with special
Write/erase
effects are disabled during Snapshot recording. In such aprotection tab
case, the icon blinks.
I If shooting is not performed for approx. 5 minutes when
the Power Switch u is set to O� or O� and power is
supplied from the battery pack, the camcorder shuts off
automatically to save power. To perform shooting again,.....slide the write/erase protection tab on the side
close the LCD monitor and re-open it. When using theof the memory card in the direction of LOCK.
viewfinder, push back it in and pull it out again.This prevents the memory card from being
I The Motor Drive mode ( pg. 25) is disabled when the
recorded over. To record on this memory card,
VIDEO/MEMORY Switch 4 is set to MEMORY.
slide the tab back to the position opposite to
I Still images taken are compliant to DCF (Design rule for
LOCK before loading it.
Camera File system). They do not have any compatibility
with devices which are not compliant to DCF.
EN
MEMORY CARD RECORDING17
01 GR-D70/60EK 17-221702.12.4, 17:05 |