MasterPage: Left
GR-DF428AH.book Page 44 Friday, March 18, 2005 5:07 PM
EDITING44 EN
Insert Editing
You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and out points. The original audio remains
unchanged.
I Use the provided remote control.
NOTES:
I Before performing the following steps, make sure
that ?TIME CODE? for CAMERA DISPLAY and
VIDEO DISPLAY is set to ?ON?.
( pg. 27, 30, 32)
I Insert Editing is not possible on a tape recorded in
the LP mode or on a blank portion of a tape.
1Play back the tape, locate the Edit-Out point
and press PAUSE (9). Confirm the time code at
this point. ( pg. 21)
2Press REW (3) until the Edit-In point is
located, then press PAUSE (9).
3Press and hold INSERT (I) on the remote
control, then press PAUSE (9). The ?9I?
indicator and the Time Code (min.:sec.) appear
and the camcorder enters Insert-Pause mode.
4Press START/STOP to begin editing.
I Confirm the insert at the time code you checked in
step 1.
I To pause editing, press START/STOP. Press it
again to resume editing.
5To end Insert Editing, press START/STOP,
then STOP (8).
NOTES:
I Program AE with special effects ( pg. 38) can
be used to spice up the scenes being edited
during Insert Editing.
I During Insert Editing, the date and time
information changes.
I If you perform Insert Editing onto a blank space on
the tape, the audio and video may be disrupted.
Make sure you only edit recorded areas.
I During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Editing stops. ( pg. 48) |
ACEC
