EN 69
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording
with minimal picture distortion at the in- and out-points. The original audio remains unchanged.
NOTES:
cInsert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.
cTo perform Insert Editing while watching in the television, make connections (Z pg. 56, 57)
6w
Remote sensor
TC 12 : 34
RM-V711U (provided)
Lock button
START/STOP
TW
DISPLAY
PLA
YINSERT
5SOFF
MA
PLAY
PAUSE
Power Dial
REW(IND)
FIND EDIT OUT POINTSTOP EDITING
1Playback the tape to locate the point where6Press STOP while the camcorder is in the
you want to stop editing. Confirm the timeInsert-Pause mode.
code at this point (Z pg. 55).
NOTES:
FIND EDIT IN POINTcP.AE/Effects (Z pg. 42) can be used to spice up
2Press REW until the point is located, then pressthe scenes being edited during Insert Editing.
PAUSE.cTo display the Time Code during Insert Editing,
(Z pg. 54).
PREPARE FOR INSERT EDITING
cWhen performing Insert Editing, the tapeOs Video
3Press and hold INSERT on the remote control,
Area and Sub-Code Area (Z pg. 6) are rewritten,
then press PAUSE. O6w� and the Time Code
so the date and time information changes.
(min.:sec.) appear and the camcorder enters
cIf you perform Insert Editing onto a blank space
Insert-Pause mode.
on the tape, the audio and video may be
disrupted. Make sure you only edit recorded
START RECORDING
areas.
4Press START/STOP to begin editing.
cDuring Insert Editing, when the tape moves to
YConfirm the insert at the time code youscenes recorded in the LP mode or a blank
checked in step 1.portion, Insert Edting stops and OERROR! REFER
MANUAL� appears.
PAUSE DURING EDITING
5Press START/STOP. The camcorder re-enters
Insert Pause mode. Press again to resume
editing. |
ACEC
