Master Page: Left
GR-DV5000Asia.book Page 12 Wednesday, March 12, 2003 5:46 PM
12 EN
I Some tripods are not equipped with studs.
Grip Adjustment
1Adjust the velcro strip.
2Pass your right hand through the loop and grasp
the grip.
3Adjust your thumb and fingers through the grip to
easily operate the Recording Start/Stop Button,
Power Switch and Power Zoom Lever. Be sure to
fasten the velcro strip to your preference.
CAUTION:
When attaching the camcorder to a tripod, extend
its legs to stabilise the camcorder. It is not advised
to use small sized tripods. This may cause damage
to the unit by falling over.
LCD Monitor And Viewfinder
Viewfinder Adjustment
1Set the Power Switch to ?A? or ?M? while While using the LCD monitor:
Make sure the viewfinder is pushed back in. Press
pressing down the Lock Button located on the
switch.PUSH OPEN and open the LCD monitor fully. It can
rotate 270o (90o downward, 180o upward).
2Make sure the LCD monitor is closed and locked.
Pull out the viewfinder fully and adjust it While using the viewfinder:
manually for best viewability.Make sure the LCD monitor is closed and locked.
Pull out the viewfinder fully.
3Turn the Dioptre Adjustment Control until the I Be sure to pull out the viewfinder until you hear a
indications in the viewfinder are clearly focused.
click, otherwise it may be pushed back in during
use.
180�
PAUSE
PUSH OPEN Button
NOTES:
I The image will not appear simultaneously on the Dioptre Adjustment Control
LCD monitor and the viewfinder except during
Interface Shooting.( pg. 18) When the
CAUTION:viewfinder is pulled out while the LCD monitor is
When retracting the viewfinder, take care not to opened, you can select which one to use. Set
pinch your fingers.
?PRIORITY? to the desired mode in SYSTEM
Menu. ( pg. 31, 38)
Tripod MountingI Coloured bright spots may appear all over the LCD
monitor or the viewfinder. However, this is not a
To attach the camcorder to a tripod, align the malfunction. ( pg. 72)
direction stud and screw to the mounting socket and
stud hole on the camcorder. Then tighten the screw
clockwise. |
ACEC
