EN33
TELEOFFUsually the distance to a subject where the lens is in focus depends on the
MACROzoom magnification. Unless there is a distance more than 1m (3.3 ft.) to the
subject, the lens is out of focus at the maximum telephoto setting. When set
to OON�, you can shoot a subject as large as possible at a distance of approx.
ON
60 cm (2 ft.).
YDepending on the zoom position, the lens may go out of focus.
WIDEOFFRecords with no change in the screen ratio. For playback on a TV with a
MODEnormal screen ratio.
CINEMAInserts black bands at the top and bottom of the screen. During playback on
wide-screen TVs, the black bands at the top and bottom of the screen are cut
and the screen ratio becomes 16:9. appears. When using this mode, refer
to your wide-screen TVOs instruction manual. During playback/recording on
MANUAL4:3 TVs/LCD monitor/viewfinder, black bands are inserted at the top and
bottom of the screen and the image appears like a letterboxed 16:9 movie.
SQUEEZE For playback on TVs with an aspect ratio of 16:9. Naturally expands the
image to fit the screen without distortion. appears. When using this
mode, refer to your wide-screen TVOs instruction manual. During playback/
recording on 4:3 TVs/LCD monitor/viewfinder, the image is elongated
vertically.
WINDOFFDisengages the function which cuts down on noise created by wind.
CUT
ON Helps cut down on noise created by wind. O� appears. The quality of the
sound will change. This is normal.
BEEPOFFEven though not heard while shooting, shutter sound is recorded on the tape.
BEEPThe beep sounds when the power is turned on or off, and at the beginning
and end of recording. Also to activate the shutter sound effect ( pg. 23).
MELODYInstead of a beep, a melody sounds when any operation is performed. It also
activates the shutter sound effect ( pg. 23).
TALLYOFFThe tally lamp remains off at all times. SYSTEM
ONThe tally lamp comes on to signal the start of recording.
IDThis number is necessary when connecting the camcorder to a device such as a computer
NUMBER using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting is 06.
: Factory-preset
NOTES:
IThe O MANUAL� settings are effective only when the Power Switch is set to O �.
IO SYSTEM� functions which are set when the Power Switch is set to O � are also applied when the
Power Switch is set to O� ( pg. 35).
CONTINUED ON NEXT PAGE |
ACEC
