10 ENGETTING STARTED (cont.)
Grip Adjustment
Power1Separate the Velcro strip.
Zoom Lever
2Pass your right hand through the loop and grasp
the grip.
Recording3Adjust your thumb and fingers through the grip, to
Start/Stop buttoneasily operate the Recording Start/Stop button and
Power Switch and Power Zoom Lever. Be sure to
fasten the Velcro strip to your preference.
Power Switch
Viewfinder Adjustment
AUTO� or OMANUAL�
Dioptre1Set the Power Switch to O
Adjustment Controlwhile pressing down the Lock Button located on the
switch.
2Turn the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.
PAUSE
Shoulder Strap Attachment
1Make sure the battery pack is removed. Following
the illustration, thread the strap through the eyelet 1,
2
then fold it back and thread it through the buckle 2.
Repeat the procedure to attach the other end of the
strap to the other eyelet 3 located under the Grip
1
Strap. Confirm the strap is not twisted.
3
Tripod Mounting
CAUTION
When attaching the camcorder to a tripod, extend its
legs to stabilise the camcorder. It is not advised to
use small sized tripods. This may cause damage to
the unit by falling over.
1To attach the camcorder to a tripod, align the
direction stud and screw to the mounting socket and
stud hole on the camcorder. Then tighten the screw
clockwise. Some tripods are not equipped with studs. |
ACEC
