GETTING STARTED (cont.)
10 EN
Power Zoom Lever
Grip Adjustment
Separate the Velcro strip.
1
Recording Start/Pass your right hand through the loop and grasp
Stop button2the grip.
Adjust your thumb and fingers through the grip,
3to easily operate the Recording Start/Stop button
and Power Switch and Power Zoom Lever. Be
sure to fasten the Velcro strip to your preference.
Power Switch
Viewfinder Adjustment
Set the Power Switch to O � or O � while
Diopter
1pressing down the Lock Button located on the
Adjustment Control
switch.
Turn the Diopter Adjustment Control until the
2indications in the viewfinder are clearly
focused.
PAUSE
Shoulder Strap Attachment
Make sure the battery pack is removed.
1Following the illustration, thread the strap
through the eyelet 1, then fold it back and
thread it through the buckle 2. Repeat the
procedure to attach the other end of the strap to
21the other eyelet 3 located under the Grip Strap .
Confirm the strap is not twisted.
3Tripod Mounting
CAUTION:
When attaching the camera to a tripod,
extend its legs to stabilize the camcorder. It
is not advised to use small sized tripods.
This may cause damage to the unit by
falling over.
To attach the camera to a tripod, align the
1direction stud and screw to the mounting socket
and stud hole on the camera. Then tighten the
screw clockwise. Some tripods are not
equipped with studs. |
ACEC
