FOR RECORDING (cont.)
50 EN
Fade/Wipe EffectsFADE/WIPE SELECTION (, , , ,
, , , , and )
These effects let you make pro-style scene
Fade or Wipe works when video recording is started or
transitions. Use them to spice up the transition
when you stop recording.
from one scene to the next. You can also vary
transitions from scene to scene.
Set the VIDEO/MEMORY Switch to OVIDEO�, then
IMPORTANT:1set the Power Switch to O � while pressing down
Some Fade/Wipe Effects cannot be used withthe Lock Button located on the switch. Open the
certain modes of Program AE with specialLCD monitor fully or pull out the viewfinder fully.
effects ( pg. 48, 49). If an unusable Fade/
Wipe Effect is selected, its indicator blinks orPress MENU. The Menu Screen appears.
2
goes out.
VIDEO/MEMORYPress + or � to select O WIPE/FADER�, then press
Switch3SET/SELECT.
Press + or � to select the desired function, then press
Recording Start/4SET/SELECT. Selection is complete. Press SET/
Stop Button
SELECT again.
YThe WIPE/FADER Menu disappears and the effect
is reserved. The indicator representing the selected
Power Switch
effect appears.
Press the Recording Start/Stop Button to activate the
5Fade-in/out or Wipe-in/out.
To Deactivate The Selected Effect . . .
...select OOFF� in step 4.
Lock Button
PICTURE WIPE OR DISSOLVE SELECTION
(, , , , , and )
MENU Button
The Picture Wipe or Dissolve works when video
recording is started.
SET/SELECT Button+, � Button
Follow steps 1 through 4 above.
1
Engage the Record-Standby mode.
2
If you select Picture Wipe/Dissolve during recording . . .
.... press the Recording Start/Stop Button when one
scene is finished. The point at which the scene
ended is stored in memory.
If you select Picture Wipe/Dissolve during Record-
Standby mode . . .
NOTES:.... press the Recording Start/Stop Button to start
IYou can extend the length of a Fade or Wiperecording and press it again when one scene is
by pressing and holding the Recording Start/finished. The point at which the scene ended is
Stop Button.stored in memory.
IIf the power is turned off after a scene is
If you select Picture Wipe/Dissolve during Record-
finished recording, the stored point is
Standby mode after performing a Picture Wipe/
erased, disabling the Picture Wipe/Dissolve
Dissolve . . .
combination. When this happens, the
.... the point at which the scene ended is already
Picture Wipe/Dissolve indicator blinks. Also
stored in memory.
note that power shuts off automatically if 5
minutes elapse in the Record-Standby mode.
If you start recording a new scene within 5 minutes of
IThe sound at the end of the last recorded3the end of the previous recording (without having
scene is not stored.
turned the camcorderOs power off), the previous scene
wipes out, revealing the new scene. |
ACEC
