Master Page: Right
GR-DVP9-8PAL.book Page 71 Friday, February 7, 2003 12:35 PM
EN 71
Memory Cards... in places subject to soot or steam such as near
a cooking stove.
To properly use and store your memory cards, be ... in places subject to excessive shock or
sure to read the following cautions:vibration.
1. During use?... near a television set.
... make sure the memory card bears the SD or ... near appliances generating strong magnetic or
MultiMediaCard mark.electric fields (speakers, broadcasting
... make sure the memory card is positioned antennas, etc.).
properly when inserting.... in places subject to extremely high (over
2. While the memory card is being accessed 40°C) or extremely low (under 0°C)
(during recording, playback, deletion, temperatures.
initialisation, etc.)?3. DO NOT leave the unit?
... never unload the memory card and never turn ... in places of over 50°C.
off the camcorder.... in places where humidity is extremely low
3. Store memory cards?(below 35%) or extremely high (above 80%).
... away from heaters or other heat sources.... in direct sunlight.
... out of direct sunlight.... in a closed car in summer.
... where they won?t be subject to unnecessary ... near a heater.
shock or vibration.4. To protect the unit, DO NOT?
... where they won?t be exposed to strong ... allow it to become wet.
magnetic fields (such as those generated by ... drop the unit or strike it against hard objects.
motors, transformers or magnets).... subject it to shock or excessive vibration
during transportation.
LCD Monitor... keep the lens directed at extremely bright
objects for long periods.
1. To prevent damage to the LCD monitor,... expose the lens and viewfinder?s lens to direct
DO NOT?sunlight.
... push it strongly or apply any shocks.... carry it by holding the LCD monitor or the
... place the camcorder with the LCD monitor on viewfinder.
the bottom.... swing it excessively when using the hand strap
2. To prolong service life?or the grip.
... avoid rubbing it with coarse cloth.... swing the soft camera case excessively when
3. Be aware of the following phenomena for LCD the camcorder is inside it.
monitor use.
These are not malfunctions:
While using the camcorder, the surface around
the LCD monitor and/or the back of the LCD
monitor may heat up.
If you leave power on for a long time, the
surface around the LCD monitor becomes hot.
Main Unit
1. For safety, DO NOT?
... open the camcorder?s chassis.
REFERENCES
... disassemble or modify the unit.
... short-circuit the terminals of the battery pack.
Keep it away from metallic objects when not
in use.
... allow inflammables, water or metallic objects
to enter the unit.
... remove the battery pack or disconnect the
power supply while the power is on.
... leave the battery pack attached when the
camcorder is not in use.
2. Avoid using the unit?
... in places subject to excessive humidity or
dust.
CONTINUED ON NEXT PAGE |
ACEC
