MasterPage: Left
GR-DX317PAL.book Page 14 Friday, March 5, 2004 12:52 PM
GETTING STARTED14 EN
Loading/Unloading A CassetteLoading/Unloading A Memory Card
The camcorder needs to be powered up to load or eject a The provided memory card is already inserted in the
cassette. camcorder at the time of purchase.
Card Cover (MEMORY CARD)
PUSH HERECassette holder
coverMemory card
OPEN/EJECT
Erase protection tab
Clipped edge
Write/erase protection tab
Label
Cassette holder Make sure the window side 1Make sure the camcorder?s power is off.
is facing out.
2Open the card cover (MEMORY CARD).
3To load a memory card, firmly insert it with its
1Slide and hold OPEN/EJECT in the direction of the clipped edge first.
arrow, then pull the cassette holder cover open until it To unload a memory card, push it once. After the
locks. The cassette holder opens automatically.memory card comes out of the camcorder, pull it out.
I Do not touch internal components.I Do not touch the terminal on the reverse side of the label.
2Insert or remove a tape and press ?PUSH HERE? to 4Close the card cover.
close the cassette holder.
To protect valuable files (available only for SD
I Be sure to press only the section labelled ?PUSH HERE? to Memory Card)
close the cassette holder; touching other parts may cause
Slide the write/erase protection tab on the side of the
your finger to get caught in the cassette holder, resulting in
memory card in the direction of ?LOCK?. This prevents
injury or product damage.
the memory card from being recorded over. To record on
I Once the cassette holder is closed, it recedes
this memory card, slide the tab back to the position
automatically. Wait until it recedes completely before
closing the cassette holder cover.opposite to ?LOCK? before loading it.
I When the battery pack?s charge is low, you may not be able
NOTES:
to close the cassette holder cover. Do not apply force.
I Some brands of memory cards are not compatible with this
Replace the battery pack with a fully charged one or use camcorder. Before purchasing a memory card, consult its
AC power before continuing.manufacturer or dealer.
3Close the cassette holder cover firmly until it locks into I Before using a new memory card, it is necessary to format
place.the card. ( pg. 26)
To protect valuable recordingsATTENTION:
Slide the erase protection tab on the back of the tape in Do not insert or remove the memory card while the
the direction of ?SAVE?. This prevents the tape from camcorder is turned on, as this may cause the memory card
being recorded over. To record on this tape, slide the tab to be corrupted or cause the camcorder to become unable to
recognise whether or not the card is installed.
back to ?REC? before loading it.
NOTES:
I If you wait a few seconds and the cassette holder does not
open, close the cassette holder cover and try again. If the
cassette holder still does not open, turn the camcorder off
then on again.
I If the tape does not load properly, open the cassette holder
cover fully and remove the cassette. A few minutes later,
insert it again.
I When the camcorder is suddenly moved from a cold place
to a warm environment, wait a short time before opening
the cassette holder cover. |
ACEC
