EN39
Basic ConnectionsTape Dubbing
CONFIRM POWER-OFF STATUSCONNECT EQUIPMENT
1Make sure the camcorderOs power is off.1Following the illustration on pg. 38, connect the
camcorder and the VCR.
CONNECT CAMCORDER TO TV OR
2VCRPREPARE FOR DUBBING
Pull out the connector cover and open it.2Set the camcorderOs Power Switch to OPLAY�,
Connect as shown in the illustration (Z pg. 38).turn on the VCROs power, and insert the
appropriate cassettes in the camcorder and the
If using a VCR . . . go to step 3.VCR.
If not . . . go to step 4.
SELECT VCR MODE
CONNECT VCR OUTPUT TO TV3Engage the VCROs AUX and Record-Pause
3INPUTmodes.
Refer to your VCROs instruction manual.
FIND EDIT-IN POINT
SUPPLY POWER4Engage the camcorderOs Play mode to find a spot
4Turn on the camcorder, the VCR and the TV.just before the edit-in point. Once it is reached,
press PLAY/PAUSE (4/6) on the camcorder.
SELECT MODE
5Set the VCR to its AUX input mode, and set theSTART EDITING
TV to its VIDEO mode.5Press PLAY/PAUSE (4/6) on the camcorder and
engage the VCROs Record mode.
NOTES:
cIt is recommended to use the AC Power Adapter/STOP EDITING TEMPORARILY
Charger as the power supply instead of the battery6Engage the VCROs Record-Pause mode and press
pack (Z pg. 5).PLAY/PAUSE (4/6) on the camcorder.
PLAYBACKcTo monitor the picture and sound from the
camcorder without inserting a tape, set theEDIT MORE SEGMENTS
camcorderOs Power Switch to OCAMERA� (OAUTO�7Repeat steps 4 through 6 for additional editing,
or OPRO.�), then set your TV to the appropriatethen stop the VCR and camcorder when
input mode.finished.
cMake sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
cIf you have a TV or speakers that are not specially
shielded, do not place the speakers adjacent to the
TV as interference will occur in the camcorder
playback picture. |
ACEC
