TH-A9R
Removing the front panel assembly and C
the DVD mechanism base
Bottom panel
(See Figs.3 to 7)
Prior to performing the following procedure, remove the
left and right side covers.
Also remove the DVD door.
(Note) Remove the front panel assembly and the
DVD mechanism together, just as they were
assembled.Front panel assembly
Fig.3
The mechanism slide switch for pickup protection
should be set to the SHORTED position.
DVD mechanism base
1. Remove the three screws (C) that retain the front
panel assembly, from the bottom panel of the unit.
2. Remove four screws (D) that retain the DVD mechanism
DD
base, from the top of the unit.
3. Remove the three screws (E) from the rear panel of
the unit that retain the DVD mechanism base.
4. Remove the DVD mechanism together with the front
panel assembly by lifting them upward from the
main unit and moving them toward the front.Front panel assembly
Fig.4
5. Disconnect the card wire of the DVD mechanism
from the connector CN101 on the DVD servo board.
DVD mechanism base
Front panel assemblyE
Disconnect the wire of the LED board from the
connector CN812 on the analog input/output board.
DVD servo board
CN101DVD mechanism assembly
Rear panel
EE
LED boardFig.5
DVD mechanism base
Front panel assembly
DVD servo boardAnalog I/O board
Analog I/O board
CN101 CN812
CN812
Fig.7
Fig.6
1-7 |
ACEC
