EN21
Quick Review (for scenesVideo Light: To brighten the scene when
recorded onto a tape): To check the endnatural lighting is too dim.
of the last recording.1) Set LIGHT OFF/AUTO/ON as required:
1) Make sure the camcorder is in the Record�StandbyOFF: Turns off the light.
mode.AUTO : Automatically turns on the light when the
2) Press 2 and release quickly.camcorder senses insufficient lighting on
Tape is rewound for approx. 2 seconds andthe subject.
played back automatically, then pauses inON: Always keeps the light on as long as the
Record�Standby mode for the next shot.camcorder is turned on.
IDistortion may occur at the start of playback. ThisIThe video light can only be used with the
is normal.camcorderOs power on.
IIt is recommended to set the white balance
Retake: To re-record certain segments.( pg. 46) to when you use the video light.
1) Make sure the camcorder is in the Record�StandbyIWhen not using the video light, turn it off to save
mode.battery power.
2) Press and hold either RETAKE to reach the startIEven if the battery indicator () does not blink
point for new recording. Pressing 3 forwards theif the battery packOs charge is low, the camcorder
tape and pressing 2 reverses it.may turn off automatically when you turn on the
3) Press the Recording Start/Stop Button to startvideo light, or when you start recording with the
recording.video light turned on.
INoise bars appear and pictures may becomeIWhen LIGHT OFF/AUTO/ON is set to OAUTO�:
monochrome or darken during Retake. This isYDepending on the lighting conditions, the video
normal.light may keep turning on and off. In this case,
manually switch the light on or off using LIGHT
OFF/AUTO/ON.
YWhile the OSports� or OHigh Speed Shutter�
mode ( pg. 38) is engaged, the light is likely
to stay on.
YWhile the OTwilight� mode ( pg. 38) is
engaged, the light will not activate.
DANGER
The video light can become extremely hot.
Do not touch it either while in operation or
soon after turning it off, otherwise serious
injury may result.
Do not place the camcorder into the carrying
case immediately after using the video light,
since it remains extremely hot for some time.
When operating, keep a distance of about 30
cm (11-13/16") between the video light and
people or objects.
Do not use near flammable or explosive
materials.
It is recommended that you consult your
nearest JVC dealer for replacing the video
light. |
ACEC
