HOW TO USE THE PAGING/CALL FUNCTIONTROUBLESHOOTING
12What appears to be a malfunction may not always be serious. First make
sure...
ENGLISH
SymptomsCauseRemedy
No sound.Is the transmitterOs power OFF?Check the connection of the
transmitter.
Turn the power on the connected AV
equipment ON and start playing.
Is the headphonesO power OFF?Widen the headphones to wear it and
the power will turn on automatically
(the indicator lights).
Is the battery in the headphones Fully charge the headphones.
exhausted?
34
Is the volume of the headphones set Adjust the volume of the head-
to the minimum level?phones to the appropriate level.
Is the volume of the connected ARaise the vV olume level of the
equipment set to the minimum leconnected Avel?V equipment as high as
possible without causing distortion.
No sound fromIs the transmitter connected to Connect them with an optional plug
the R-channel.equipment with monaural audio adaptor. (Converts monaural audio
output?output to stereo audio output.)
Distorted sound.Is the battery in the headphones Fully charge the headphones.
exhausted?
Is the volume of the connected AAdjust the vV olume level of the
equipment set too high?connected AV equipment as high as
possible without causing distortion.
The transmitter has a built-in microphone for transmitting your voice, etc. to the
headphones.Noisy sound.Is the battery in the headphones Fully charge the headphones.
Microphoneexhausted?
CALL
Are the frequency modulation signals Wear the headphones again to
1. To send a message to the person wearing
being received correctly?switch the power back on, then tune
the headphones, press the CALL button on
again.
POW
the transmitter and speak into it. Your voiceER / CHARGE
OFFTruBassWOIs there a possibility of interference? Switch the transmitter channel, wear is transmitted to the headphones as long asWSURROU
ND
MINLEVELMAXthe headphones again to switch the
the CALL button is pressed (the line inputpower back on, then tune again.
sound is interrupted while the CALL buttonIs the volume of the connected AAdjust the vV olume level of the
is pressed). equipment set too low?connected AV equipment as high as
possible without causing distortion.
2. The microphone is next to the CALL button. Speak into it from at least 4 inchesAre the headphones too far awUse them within the ray ange the
(10cm) away. Speaking too close to the microphone or speaking too loudly mayfrom the transmitter?frequency modulation signal can
reach. (Refer to page 11)
cause the sound transmitted to the headphones to the distorted.
Battery chargingHas the rechargeable battery Replace it with a new battery. Refer
3. Pressing the CALL button while wearing the headphones may cause feedback
is impossible.expired?to page 13 or consult your dealer for
(a howling sound) to occur. Turn the volume down on the headphone beforereplacement.
pressing the CALL button.
1819 |