Quick Setup Getting Started
Getting Started
These quick setup pages will provide you, in three easy steps, with the basic information you
need to begin using your new television right away.
If you have questions, or for more detailed information on any of these steps, please consult
other sections of this manual.
Step 1 - The Remote Control
Before you can operate your remote
control, you first need to install the
batteries (included).
Slide the cover on the back of the
remote down towards the bottom of
the remote control. Insert two batteries
(included) carefully noting the ?+? and
?-? markings, placing the ?-? end in the
unit first. Slide the cover back into place.
When you change the batteries, try to complete the task within three minutes. If you take
longer than three minutes, the remote control codes for your VCR, DVD, and/or cable
box/satellite receiver may have to be reset. See pages 25 - 28.
Key Feature Buttons
The four key feature buttons at the center of the remote can be MUTINGC.C.
used for basic operation of the television. The top and bottom C.C.
buttons will scan forward and back through the available CH
channels. To move rapidly through the channels using
JVC?s Hyperscan feature, press and hold CH+ or CH -. The VOLOKVOL
channels will zip by at a rate of five channels per second. The
right and left buttons will turn the volume up or down. These CH
buttons are also marked with four arrows and are used with
JVC?s onscreen menu system. To use the onscreen menus, MENUBACK
press the MENU button.
12
HD-ILA Eng 125/6/04, 9:51:03 AM |
ACEC
