HV-29JH24/29JH54/29JH74/29VH14/29VH54 / GGT0056-001A-H / English
04_Eng.book.fm Page 16 Friday, August 6, 2004 2:00 PM
Remote control buttons and functions
? When you exit the Twin or PIP mode, For the sub picture:
the sub picture lastly displayed will be Press the (Input) button.
saved, and it will appear next time.Each time you press the button, the input
? The following table shows what will source changes as follow (the one used for
happen if the same input sources are the main picture will be skipped):
chosen for both main and sub pictures VIDEO-1 ? VIDEO-2 ? VIDEO-3 ?
when you enter the Twin or PIP mode. VIDEO-4 ? TV
If the main picture is the same as the sub
Swapping the pictures
picture, then the sub picture will be
changed to VIDEO-1. But if the main Press the (Swap) button.
picture is VIDEO-1, then the sub picture Each time you press the button, the main
will be changed to VIDEO-2.picture and the sub picture will be swapped.
[When the same input sources are chosen]
Changing the sub picture
Main pictureSub pictureposition (in PIP mode only)
TVTV ? VIDEO-1You can position the sub picture to one of
corners of the main picture.
VIDEO-1VIDEO-1 ? VIDEO-2
VIDEO-2VIDEO-2 ? VIDEO-1Press the (Position) button.
Each time you press the button, the sub
VIDEO-3VIDEO-3 ? VIDEO-1
picture moves clockwise (lower right ?
VIDEO-4VIDEO-4 ? VIDEO-1
lower left ? upper left ? upper right).
? If you press the PIP button when
Setting the colour system of the
receiving the Progressive Video Signal
sub picture
(525P or 625P signal), "525P" or
You can choose the colour system of the
?625P? appears on the screen and the
sub picture.
Twin/PIP function does not operate.
While the sub picture is being displayed,
TV channel selectionpress the C.SYS button.
Each time you press the button, the colour
For the main picture:
system of the sub picture changes as
Choose a channel using the CHANNEL-/+
follows:
buttons or the number buttons.
AUTO ? PAL ? SECAM ? NTSC3.58 ?
For the sub picture:
NTSC4.43
Choose a channel using the SUB-P-/+
? For all source, normally choose AUTO.
buttons.
? The chosen colour system will not be
Input source selection (TV, saved.
VIDEO-1, -2, -3 or -4)? If the main picture and the sub picture
are of different colour systems, there
For the main picture:
will be some differences in the size of
Press the TV/VIDEO button.
the sub picture and flicker may take
Each time you press the button, the input
place.
source changes as follows (the one used for
the sub picture will be skipped):
VIDEO-1 ? VIDEO-2 ? VIDEO-3 ?
VIDEO-4 ? TV
16 |
ACEC
