Common Operations
Setting the ClockTurning On the Power and Selecting the
Sources
Before operating the unit any further, first set the clock built
in this unit.When you press the play button for a particular source (FM/
PANELAM, CD 6, AUX, and TAPE 2 3), the unit turns on, and
OPEN / CLOSE
1Press PANEL OPEN/CLOSE.the Powered Rolling Panel opens automatically (and the unit
The unit is turned on and the Powered Rollingstarts playing the source if it is ready N COMPU PLAY
Panel opens automatically.CONTROL).
TIMERTo listen to the FM/AM broadcasts, press FM/AM. (See
2Press TIMER/CLOCK./CLOCK
page 12.)
To play back CDs, press CD 6. (See pages 13 � 15.)
To play back taprpes,ess T APE 2 3. (See page 16.)
To select the external equipment as the sour press AUX.ce,
The hour digits start flashing on the display.
PRESETFM AM/TAPE
CD
AUX
3Press 4 or c to adjust the
hour, then press SET.
STANDBY
To turn on the unit without plapressying,
SEA CONTROLso that the STANDBY lamp goes off.
SET
Y If you want to correct the hour after pressing
SET, press CANCEL. The hour digits start
flashing again.
The Powered Rolling Panel opens automatically.
PRESET
4Press 4 or c to adjust the
To turn off the unit (on standby), pressSTANDBY
minute, then press SET.
again so that the STANDBY lamp lights up.
The Powered Rolling Panel also closes.
A little power is always consumed even while the
SEA CONTROLunit is on standby.
SET
To switch off the power supply completelyunplug the , AC
power cord from the AC outlet.
To check the clock time
DISPLAY
Press DISPLAY while playing any source.
Y Each time you press the button, the sourceWhen you unplug the AC power cord or if a power
indication and the clock time alternate on thefailure occurs
display.The clock is reset to O0:00� right away, while the tuner preset
stations (see page 12) will be erased in a few days.
To adjust the clock again
If you have adjusted the clock before, you need to press
TIMER/CLOCK repeatedly until the clock setting mode is
selected.
Y Each time you press the button, the timer/clock setting
modes change as follows:
DAILYON TIMEREC
CanceledClockON TIME
setting
(The hour digits start flashing.)
If there is a power failure
The clock loses the setting and is reset to O0:00.� You need to set the
clock again.
� 9 �
EN01-12.MX-J50[A]/1999.4.15, 10:57 AM |
ACEC
