Timer operations
CD-206/204/203/DPF-R6010/R4010/R3010 (En)
Timer playback of CD can be started at any time using an
This unit
audio timer which is available in audio stores.
23
System control cordAudio cord
Preparation�Connect the power cords of the associated
components so that their power can be
turned ON through the audio timer.
(Also, be sure to read carefully the instruc-
tion manual of the timer.)
Amplifier
12 : 00
Audio timerTo wall AC outlet
Turn the powers of the associated components
1�If the amplifier is not connected to the CD player through a system
ON.
control cord, select the "CD" input with the input selector.
Preparation
2
Load a disc in the CD player.9
Label side
Set the amplifier volume.
3
1Play the disc.
6
Adjusting the volume:
Set the volume the maximum (0 dB) using the OUTPUT
2Adjust the amplifier volume.NoteNote
(UP) key on the remote control unit (Except CD-203/DPF-
(Use the remote control unit (Except CD-
R3010) , and adjust the volume to the desired level on the203/DPF-R3010) of this unit to adjust the
amplifier side.
volume to the maximum level.)
(Since the sound output is at the maximum level when the power
3Stop the disc.is turned on, lowering the level with the remote control unit will
change the volume.)
7
Set the timer ON time.
4
Set the timer so that it supplies
power at the specified time.�With some audio timer models, the power is automatically turned OFF
when the timer ON time is set. With such a model, skip step 5 below.
Turn OFF the power output from the audio
5
timer.
�Do not touch the ON/STANDBY (POWER/) switches of the
amplifier and CD player.
�When the set time comes, the disc playback starts automatically.
1. Some amplifiers cannot be used with a timer. Before using a amplifier, check it.
NotesNotes2. When operating the unit other than CD player using an audio timer, be sure to remove the disc from the CD player. |