Troubleshooting Guide
External Disc Control Mode
PROBLEMPOSSIBLE CAUSESOLUTION
The disc control mode cannotNo wire has been connected to the disc changer inputConnect the wire to the disc changer input terminal on the
be selected.terminal on the unit.unit.
English
The specified disc does notThe specified CD is quite dirty.Clean the CD.
play, but another one plays
instead.The CD is upside-down.Load the CD with the labeled side up.
The disc is loaded in a different slot from that specified.Eject the disc magazine and check the number for the
specified disc.
The disc is severely scratched.Try another disc instead.
The sound skips.Something is touching the disc changer.Remove whatever is touching it.
The CD is scratched or dirty.If skipping happens at the same place when the car is
stopped, something with the CD is wrong. Clean the CD.
The display shows that theThe computer chip in the unit is not functioning normally.Press the reset button on the unit (see p. 4).
changer is being played, but no
sound can be heard.
The specified track will notRandom play or magazine random play has been selected.Turn off random play or magazine random play (see p. 20).
play.
If the following situations, consult your nearest service center:
Y Even though the disc changer is connected, the Disc Changer Mode is not on, with "AUX Mode" showing in the display during the Changer
Mode.
Y Even though no device (KCA-S210A, CA-C1AX, KDC-CPS87, KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, "AUX
Mode" is displayed when switching modes.
The following messages are displayed when certain problems are occurring in your system. Take the recommended
actions.
EJECTNo disc magazine has been loaded in the changer. The disc magazine is not completely loaded.
]Load the disc magazine properly.
No DiscNo disc has been loaded in the disc magazine.
]Load a disc into the disc magazine.
N 42 N |
ACEC
