14
Set Up functions
DVF-3080/DVF-8100 (EN/K,P,E,X,Y)
LANGUAGE AUDIO
Each DVD disc has a variety of audio output options. Set
the playerOs AUDIO options according to the type of
audio system you use.
Menu Language
Select a language for the Setup menu and on-screen
display.
Disc Audio/ subtitle/ Menu Dolby Digital/ DTS/ MPEG
Select the language you prefer for the audio Track (discBitstream: Select "Bit stream" if you connect the DVD
Preparationsaudio), subtitles, and the disc menuPlayerOs DIGITAL OUT jack to an amplifier or other
Original: Refers to the original language in which theequipment with a Dolby Digital, DTS or MPEG de-
disc was recorded.coder.
PCM (for Dolby Digital/ MPEG): Select when con-
Other: To select another language, press number but-
nected to a two-channel digital stereo amplifier.
tons then ENTER key to enter the corresponding digit
DVDs encoded in Dolby Digital or MPEG will be auto-
number according to the language code list in the refer-
matically down mixed to two-channel PCM audio.
ence chapter. If You enter the wrong Language code,
press CLEAR key.Off (for DTS): If you select OOff'', the DTS signal is
not output through the DIGITAL OUT jack.
DISPLAYSample Freq. (Frequency)
If you receiver or amplifier is NOT capable of handling 96
kHz signals, select 48 kHz. When this choice is made, this
TV Aspect16 : 9
Display ModeWidescreenunit automatically converts any 96 kHz signals to 48 kHz
Progressive ScanOff
TV Output SelectRGBso your system can decode them.
If your receiver or amplifier is capable of handling 96 kHz
signals, select 96 kHz. When this choice is made, this unit
passes each type of signal through without any further
processing.
TV Aspect
Check the documentation for your amplifier to verify its
4:3: Select when a standard 4:3 TV is connected.
capabilities.
16:9: Select when a 16:9 wide TV is connected.
When the disc prohibits 96 kHz digital output, the signal
Display Mode always is put out after down-conversion.
Display Mode setting works only when the TV Aspect
Dynamic Range Control (DRC)
mode is set to "4:3".
With the DVD format, you can hear a program's
Letterbox: Displays a wide picture with bands on the
soundtrack in the most accurate and realistic presenta-
upper and lower portions of the screen.
tion possible, thanks to digital audio technology. How-
Panscan: Automatically displays the wide Picture on the
ever, you may wish to compress the dynamic range of
entire screen and cuts off the
the audio output (the difference between the loudest
portions that do not fit.
sounds and the quietest ones). This allows you to listen
Progressive Scan to a movie at a lower volume without losing clarity of
When ON is selected, the confirmation screen for switch-sound. Set DRC to On for this effect.
ing to Progressive Scan appears.This function operates only at the time of playback of
In case of a TV not compatible with Progressive Scan, theDVDs recorded with Dolby Digital.
screen disappears and return to the original display is
made after 10 seconds.Vocal
Set to on only when a multi-channel karaoke DVD is
TV Output Select (only for Europe)
playing. The karaoke channels on the disc mix into nor-
The TV Output Select mode is switched to RGB or YCbCr.
mal stereo sound. |
ACEC
