Removing the Unit
Removing the hard rubber frameRemoving the Unit
1 Engage the catch pins on the removal tool and 1 Refer to the section <Removing the hard rubber
remove the two locks on the upper level.frame> (page 40) and then remove the hard
Upper the frame and pull it forward as shown in rubber frame.
the figure.2 Remove the screw (M4 8) on the back panel.
3 Insert the two removal tools deeply into the slots
on each side, as shown.
Screw (M4X8)
Lock(commercially available)
Catch
Accessory2
Removal tool
2 When the upper level is removed, remove the
lower two locations.
Accessory2
Removal tool
4 Lower the removal tool toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
The frame can be removed from the bottom side in the
same manner.
Be careful to avoid injury from the catch pins on the
removal tool.
5 Pull the unit all the way out with your hands,
being careful not to drop it.
40 | English
##@JOEE@JOEE1.1. |
ACEC
