Installation
t
nCare must be taken to ensure that the appliance
does not stand on the electrical supply cable.n
Parts which heat up should not be exposed.
Important:if the supply cord is damaged, it must
Wherever possible the back of the product should
be replaced by a special cordo or assembly
be against a wall.
available from the manufacturer or its service
nIf the appliance has been transported horizontally,
agent.
it is possible that the oil contained in the
nDuring normal operation, the condenser and
compressor flows in the refrigerant circuit. It is
compressor at the back of the appliance heat up
advisable to wait at least two hours before
considerably. For safety reasons, minimum
connecting the appliance to allow the oil to flow
ventilation must be as shown in the relevant
back in the compressor.
Figure.
Attention: keep ventilation openings clear
of obstruction.Environment Protection
nIf the appliance is transported horizontallyn This appliance does not contain gasses which, it is
possible that the oil contained in thecould damage the ozone layer, in either its
compressor flows in the refrigerant circuit. It isrefrigerant circuit or insulation materials. The
advisable to wait at least two hours beforeappliance shall not be discarded together with
connecting the appliance to allow the oil tothe urban refuse and rubbish. Avoid damaging
flow back in the compressor.the cooling unit, especially at the rear near the
heat exchanger. Information on your local
nThere are working parts in this product which heat
disposal sites may be obtained from your
up. Always ensure that there is adequate
municipal authorities.
ventilation as a failure to do this will result in
component failure and possible food loss. SeenThe materials used on this appliance marked
installation instructions.with the symbol are recyclable.
DESCRIPTION OF THE APPLIANCE
AButter shelf
�Shelves
AA
�Bottle shelf
ASalad drawers
�Storage shelves
AThermostat
�
�
A
�
15 |
ACEC
