Y Do not place carbonated or fizzy drinks in theY Parts which heat up should not be exposed.
freezer as it creates pressure on the containerWherever possible the back of the product,
Instructions for totally built-in appliances
which may cause it to explode, resulting inshould be against a wall.
damage to the appliance.
Y If the appliance has been transported
Building-in instructions
horizontally, it is possible that the oil contained in
50 mmmin.Installation2the compressor ?lows in the refrigerant circuit. It
Dimensions of housing
200 cm
Y During normal operation, the condenser andis advisable to wait at least two hours before
Height 880 mm
compressor at the back of the appliance heat upconnecting the appliance to allow tloe oil to flow
Depth 550 mmconsiderably. For safety reasons, minimumback in the compressor.
ventilation must be as shown in the relevant
Width 560 mm
Figure.
For safety reasons, minimum ventilation must be asEnvironment Protection
min.Attention: keep ventilation openings clear of
shown in Fig.2
cm 200obstruction.This appliance does not contain gasses which
Attention: keep ventilation openings clear ofcould damage the ozone layer, in either its
Y If the appliance is transported horizontally, it is
obstruction.refrigerant circuit or insulation materials. The
possible that the oil contained in the compressor
D567appliance shall not be discarded together with
It is necessary that the niche is provided with aflows in the refrigerant circuit. It is advisable to
the urban refuse and rubbish. Avoid damaging
wait at least two hours before connecting the
50the cooling unit, especially at the rear near the
appliance to allow the oil to flow back in the
540
heat exchanger. Information on your local
compressor.
conduct of ventilation having the followingdisposal sites may be obtained from municipal
Y There are working parts in this product which
dimensions:authorities. The materials used on this appliance
B
heat up. Always ensure that there is adequate
marked by the symbol are recyclable. Depth 50 mm
ventilation as a failure to do this will result in
Width 540 mmcomponent failure and possible food loss. See
T Hinstallation instructions.
CONTENTS
PR01
Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
A
Use - Cleaning the interior - Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13
Slide the appliance into the recess, pushing itUse - Temperature regulation - Fresh food refrigeration - Freezing fresh food - Storage of frozen food - Thawing
against the wall on the handle side.Ice-cube production . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14
Use - Movable shelves - Positioning the door shelves - Hints - Hints for refrigeration - . . . . . . . . . . . . . . . . . .15
Hints - Hints for freezingHints for storage of frozen food - - Maintenance - Periods of no operation . . . . .
Periodic cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
Maintenance - Interior light - Defrosting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17
Customer service and spare parts- Installation- Location - Electrical connection - Fitting the decor panel . .18
Installation- Door reversibility - Inner door reversal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19
Installation- Building-in instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20
D022
Open the door and fasten the appliance with 4
screws provided in the kit included with the
appliance.
USE
Cleaning the interior
Operation
Before using the appliance for the first time, wash
Insert the plug into the wall socket.
the interior and all internal accessories with luke-
warm water and some neutral soap so as to removeOpen the refrigerator door and turn the thermostat
the typical smell of a brand-new product, then dryknob, clockwise, beyond the �OE (STOP) position.
D585
thoroughly.The appliance will start to operate. To stop
operation, simply turn the thermostat knob to
position �OE
Do not use detergents or abrasive
powders, as these will damage the finish.
2013 |
ACEC
