BEFORE USING THE DISHWASHER/
CONNECTIONS
1. Removing the packaging and controls: 4. Electrical connection:
After unpacking, make sure that the dishwasher is Closely adhere to local Electricity Board
undamaged and that the door closes correctly. If in regulations.
doubt, contact a qualified technician or your local Voltage information is shown on the rating plate
retailer.mounted inside the door on the right hand side.
? Keep the packaging materials (plastic bags, The appliance must be earthed as prescribed by law.
polystyrene parts, etc.) out of reach of children, as Do not use extension leads or multiple adapters.
they are potentially dangerous.
Before carrying out maintenance, disconnect the
This dishwasher has been factory tested to ensure mains plug.
it functions correctly.
If necessary, the power cable may be replaced with
Such testing may leave slight water marks that will one the same obtained from our After-Sales
disappear with the first wash.Service. The power cable must only be replaced by
2. Water and electrical connections:a qualified technician.
All water and electrical connections must be
carried out by a qualified technician in compliance Warning for models provided with LCD
display:
with the manufacturer's instructions (refer to the
enclosed installation booklet) and current local The mains plug must be positioned in an easily
safety regulations.accessible place.
The appliance must only be used in the household
for the prescribed uses.For Austria: if the apparatus is series connected to
a fault current switch, this must be sensitive to the
Do not use the dishwasher if it has been damaged pulsating current.
in transit. Consult your local retailer or our After-
Sales Service.
(Refer to the separate installation EC Declaration of conformity
This appliance has been designed, constructed and
instructions booklet)
distributed in compliance with the safety
3. Water inlet and drain: requirements of EC Directives:
Observe any special regulations issued by your local 73/23/EEC
Water Board. 89/336/EEC
Water supply pressure: 0.3 - 10 bar. 93/68/EEC
Make sure the inlet and drain hoses are kink-free
and are not crushed.
If the hose length is not sufficient, please contact
your local dealer or our After-Sales Service.
Load capacity:
The inlet hose must be securely clamped to the 12 place settings.
water tap to prevent leaks.
The inlet water temperature varies according to
the model installed. Inlet hose marked ?25°C Max?:
maximum temperature 25°C.
All other models: maximum temperature 60°C.
When installing the appliance, make sure the drain
water discharges correctly (if necessary, remove
the wire gauze from the sink siphon).
Fix the drain hose to the spigot with a clamp to
prevent it from coming off during operation.
For appliances with water-stop system only: If the
water connections are made correctly, the water-
stop system safeguards your home against damage
caused by flooding.
12 |
ACEC
