FIRST WASH CYCLE
We recommend that the first wash cycle be carried out empty. This will remove any residual water used
in the factory checks.
1.Turn on the tap.
2.Close the drum flaps.
3.Pour a small amount of detergent (about 30 ml) into the detergent dispenser .
4.Select a short programme and low spin speed (see programme chart).
5.Switch on the appliance.
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
1.Packing3.Disposing of packaging and old appliances
? The packaging materials are 100% recyclable and ? The washing machine is built from reusable
bear the recycling symbol. Adhere to local materials. The washing machine must be
regulations when disposing of packaging material.disposed of in compliance with current local
waste disposal regulations.
2.Energy saving tips? Before scrapping old machine, cut of the power cable
? Achieve the best use of energy, water, detergent
so that the washing machine cannot be connected to
and time by using the recommended maximum the mains.
load size.
? Remove detergent from compartment if you
? Do not exceed the detergent dosages indicated intend scrapping your appliance.
in the manufacturer?s instructions.
? The Eco Ball - a special system in the outlet - will 4.Child safety
? Children must not be allowed to play with or in
prevent detergent loss from the drum to avoid the appliance.
detergent loss into the environment.
5.General recommendations
? Use ?Prewash? for heavily soiled laundry only! ? Do not leave the appliance connected when not
Save detergent, time, water and energy
in use. Turn off the tap.
consumption by not selecting ?Prewash? for ? Before cleaning or carrying out maintenance
slight to normally soiled laundry. switch off the washing machine and disconnect it
? Pretreat stains with stain remover or soak dried
from the mains supply.
in stains in water before washing to reduce the ? To clean the outside of the washing machine, use
necessity of a hot wash program.a neutral detergent and a damp cloth.
? Save energy by using a 60° C instead of a 90° C ? Do not use abrasive detergents.
wash programme or a 40° C instead of a 60° C ? Do not attempt to force the lid open.
wash programme.? If necessary, the power cable may be replaced
? Save energy and time by selecting a high spin with an identical one obtained from our After-
speed to reduce the water content in laundry Sales Service. The power cable must only be
before using a tumble dryer (for machines with replaced by a qualified technician.
adjustable spin speed).6.EC Declaration of Conformity
? This washing machine has been designed,
constructed and distributed in compliance with
the safety requirements of EC Directives:
73/23/EEC Low Voltage Directive
89/336/EEC EMC Directive
93/68/EEC CE Marking Directive
19 |
ACEC
