And finally
What to do if?Mains plug replacement
Mistakes when controlling or missfunctions arePoor playback of soundShould your mains plug need changed and you
indicated on the screen, e.g.�PROTECTEDY Mixture of languages is heared:8are competent to do this proceed as follows. If
CASSETTEE. Follow these instructions to solveyou are in doubt contact your retailer or a
Control with sound button .
the problem.competent electrician.
Y Store receiving sound to the channel.21
In the following there are described some more
eventually happening faults.Y Disconnect the plug from the mains supply.
No recording
Y Cut off the plug and dispose of it safely. A
No functionPageY Recording mode is not obtained:8
plug with bared conductors is dangerous if
Cassette tab is missing.
Y No mains connection: 6Y Picture noise was recorded only:6, 8engaged in a live socket.
Plug-in mains cable.
Check aerial connection.Y Only fit a 13 Amp BS1363A approved plug
Y Child lock switched on:17
Select program for recording.with a 3 Amp fuse.
switch off child lock with OK+ .
Y VTR came from the cold to warm:4Timer recording problems
Y The cable wire colours or a letter will be
Wait till room temperature is reached.marked at the connection points of most
Y Timer recording impossible:16
Y Safety circuit activated:quality plugs. Attach the wires securely to
Pull mains plug for 1 minute.Set date and time first.
Y Timer recording was not done: 8, 10, 11their respective points. The Brown wire must
No VTR reception on TV Recorder was not switched off, go to the Live pin, the Blue wire must go to
when timer recording should have started. the Neutral pin and the Green/Yellow wire
Y With Euro cable no video:7Cassette tab is missing.must go to the Earth pin.
Set AV monitor mode on TV.Broadcast not transmitted (PDC on).
Check Euro cable connection.Power supply failed.Y Before replacing the plug top ensure that the
Y Without Euro cable no video:7, 20Y It was not recorded to the end:10, 11cable restraint is holding the outer sheath of
Switch on VTR transmitter.Without PDC timer set too short.the cable firmly and that the wires are
Preset channel 35 (21-55) on TV.The end of the cassette was reached.correctly connected.
Check antenna cable connection.Power supply failed during recording.
No function of remote controlCassette is not ejected
Y TV or DVD control are on:5Do not use force:
When TV or DVD display lights,Unplug shortly from mains supply and then
switch back with function button.reconnect the recorder.
Y Digital Link is switched on:18
Point remote control to TV.Reset to initial mode
Y Also no remote control for TV:5
Wanting to reset the recorder, erasing all
Batteries empty or wrong inserted.
settings including station memory, proceed as
follows:
Poor playback picture
Y Picture quality unacceptable:9Y Disconnect the recorder from mains supply.
Y Hold down off button O on the recorder front
Test with another cassette.
and reconnect mains supply.
Set tracking manually.Y Still hold down off button for about 15
Y Poor picture without Euro cable:7, 20
seconds until the display goes off shortly.
Set fine tuning on television.
The recorder is now in the initial mode and is
ready to start program search, see Page 7.
22 |
ACEC
