Everyday Operation
First InstallationSelect StationsCassettes
First connect the aerial, then plug-in theSelect stations directly.
mains supply. Programme search startsUse the number buttons toVHSVHSInsert cassette.
immediately. See OFirst InstallationO pagesenter station numbers. Two
14, 15.digit numbers need to be
entered almost
simultaneously.Insert a VHS cassette by gently sliding it into
the compartment until the recorder inserts it
Switch On/OffSelect stations upward orautomatically.
downward. If the cassette is protected against erasing,
On the set or on the remoteNumbers of unstored stationsthe recorder will immediately start playing it
control.cannot be selected.back.
If you have stored timerThe station list shows you the storedThe video recorder ejects the
TIMERCASS
recordings.programmes, see page 13.cassette at any time. You can
(on the recorder)
then remove it.
You can protect your cassette against
TV Set and Video ProgramStatus Informationaccidental erasing. On the rear of the
cassette you will find an opening covered
Set the TV set to the programOSDBBC PALwith a protection tab.
Station
AVposition provided for a videoIf you snap this tab no additional recording
recorder. See OAutomaticcan be made onto this cassette.
InstallationO page 15.Slide the cover of the remote control to itsIn order to enable renewed recording,
open position to reach the small buttons.adhesive tape must be used to cover the
The VTR/TV switch on the remote controlopening of the cassette.
must be set to VTR to allow control of theIf you want to switch the status displays on
recorder!the screen, on or off (e.g. for copying), switchTo allow the exact calculation of the
to �Main MenuE to �SettingsE to �VTRremaining playing time of the cassette, the
If you switch off the recorder, it will not befunctionsE select line �On screen displayEvideorecorder has to know the total playing
separated from the mains supply. If you want(see page 11) and change status with buttonstime of the cassette. This time is part of the
to separate it from mains supply, you will/.cassetteOs name, e.g. E180, E195, E240 ...
have to disconnect the mains connection.
To enter the length switch to �Main MenuE,
to �SettingsE, to �VTR functionsE and select
line �Tape LengthE.
� E180E stands for a length of 180 minutes
or less and �E260 E 260 minutes or more.
3
2 |
ACEC
