INSTRUCTIONS FOR THE INSTALLER
SAFETY ADVICE
-Installation of flues and ventilation for gas
" Before installation ensure that the localappliances of rated input not exceeding
stndrd
distribution conditions (gas type and60 kW (1, 2 and 3 family gases) - Part
pressure) and the pre-setting of the2 Specification for installation of
appliance are consistent.ventilation for gas appliances - BS 5440;
" This appliance must be installed only in a-Gas burning appliances - Part 3 Domestic
room with good ventilation.cooking appliances burning gas - BS
" This appliance must not connected to a flu. It5386;
has to be installed and connected in-Specification for installation of low
accordance with the rules in force. Specialpressure gas pipe work of up to 20mm
nd
attention should be paid to the applicable(R1) in domestic premises (2 family gas)
disposal concerning ventilation.- BS 6891;
" The adjacent furniture panels have to be heat-Pipe threads for tubes and fittings where
proof or protected by such material.pressure-tight joints are made on the
" The adjusting conditions of this appliance arethreads (metric dimensions) - BS 21:
mentioned on the rating plate.1985;
-Flexible hoses, end fittings and sockets
Connection to gas supply.
for gas burning appliances - BS 669;
Check that the gas flow and the diameter of theInstallation of domestic gas cooking
supply pipe is sufficient to supply all thestndrd
appliances (1, 2 and 3 family gases) - BS
appliances of the installation.
6172: 1990;
" Check that all connections are tight.
" Install an accessible and visible gas tap to
isolate the appliance.
Warning
ELECTRIC CONNECTION
The supply cable must not be routed across
Any electrical work required to install
the back of the oven.
this cooker should be carried out by a
qualified electrician or competent person, inYES
accordance with the current regulations.
This cooker must be earthed.
This cooker is designed to be connected to apower cord
240V 50Hz AC electrical supply.
Before switching on, make sure the electricity
supply voltage is the same as that indicated on
the rating plate.
Check on the rating plate the value for the
total connection power for establishing the
NO
fuse power.
Fuse capacity: 5 A
If the supply cable is damaged it must be
replaced by the manufacturer or itspower cord
service agent.
Before connecting check that:
" The plug used for connection is easily
accessible when the appliance is installed.
18 |
ACEC
