PrecautionsFeatures
1. Warranty Claimn6-Disc Carousel Changer � only from Onkyo � offers
You can Ţnd the serial number on the rear panel of this unit. In casemore music and convenience for the money
of warranty claim, please report this number.nUnique design allows users to change up to 5 discs
without interrupting disc in play
2. Power
WARNINGnNext Selection � another Onkyo exclusive � lets users
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,choose the next track/disc without interrupting the
READ THE FOLLOWING SECTION CAREFULLY.current song playing
The voltage of the available power supply differs according tonSingle-Bit PWM (Pulse Width Modulation) D/A Con-
country or region. Be sure that the power supply voltage of the areaverter to minimize lowlevel linearity problems that
where this unit will be used meets the required vplague many multi-bit playoltage (e.g., ACers � so thereOs no loss of
230 V, 50 Hz or AC 120 V, 60 Hz) written on the rear panel.musical detail during quieter passages
3. Do not touch this unit with wet handsnProprietaryAccuPulse Quartz System with Polysorb
Do not handle this unit or power cord when your hands are wet orvirtually eliminates the possibility of timing errors in
damp. If water or any other liquid enters the case, takthe clock oscillatore this unit to
an authorized service center for inspection.n8-Times Oversampling
4. Location of this unitnFixed Analog Output
Place this unit in a well-ventilated location.nVisible Display when tray is out
Take special care to provide plenty of ventilation on all sides of thisnOversized power transformer
unit especially when it is placed in an audio rack. If vn6-Mode Repeat: entirentilation ise disc, all discs, random tracks,
blocked, this unit may overheat and malfunction.
programmed tracks, random memory, single track
Do not expose this unit to direct sunlight or heating units as thisn3-Mode Time Display: Single, Elapse/Remain, Total
unitOs internal temperature may rise and shorten the life of the
Remain
pickup.
nCompatible Remote Control
Avoid damp and dusty places and places directly afn fected by vibra-Disc Intro Scan plays the Ţrst 8 seconds of each disc
tions from the speakers. In particular, avoid placing the unit on or
nDirect Track/Disc Access via remote
above one of the speakers.
nOptical Digital Output for direct digital connection to
Be sure this unit is placed in a horizontal position. Never place it
DAT/Minidisc player or DSP receiver.
on its side or on a slanted surface as it may malfunction.
Do not place near tuners or TV sets.
If placed next to a TV or tuner, it may cause reception interference
resulting in some noise in the TV or tuner output.
5. Care
From time to time you should wipe the front and rear panels and the
Supplied accessories
cabinet with a soft cloth. For heavier dirt, dampen a soft cloth in a
weak solution of mild detergent and water, wring it out dry, and
Check that the following accessories are supplied with this unit.
wipe off the dirt. Following this, dry immediately with a clean cloth.
Do not use rough material, thinners, alcohol or other chemical sol-
vents or cloths since these could damage the Ţnish or remove the
panel lettering.
6. Points to remember
Audio connection cable ´ 1 cable ´ 1
If this unit is brought from a cold environment to a warm one or is
in a cold room that is quickly heated, condensation may form on
the pickup, preventing proper operation. In this case, remove the
disc and leave the power ON for about one hour to remove the con-
densation.
Remote controller RC-331C ´ 1
When transporting this unit, be careful not to bump it.
Batteries (size AA, R6 or UM-3) ´ 2
Always close the disc tray when not loading or unloading discs to
protect delicate internal parts from dust.
Memory Preservation
This unit does not require memory preservation batteries. A
built-in memory power back-up system preserves the contents
of the memory during power failures and even when the unit is
unplugged. The unit must be plugged-in in order to charge the
back-up system.Power cable ´ 1
The memory preservation period after the unit has been
unplugged varies depending on climate and placement of the
unit. On the average, memory contents are protected over a
period of a few weeks after the last time the unit was
unplugged. This period is shorter when the unit is exposed to a
highly humid climate.
4 |
ACEC
