8 y[W QOOTNWŽPWú@�jú@��UžSO�
Listening to an FM/AM Station�Continued
Using the Remote Controller
Press the number buttons as
described in the examples
below to select the desired
preset channel.
Preset
Press
channel
8
10
Adjust the volume level.
22
(Pressing VOLUME increases
represents the tens digit.the volume level, and pressing
VOLUME decreases the
level.)
Selects an FM/AM station.
Selects a preset channel.
Enables you to manually
(Pressing selects a lower
tune in a broadcast station.channel number and pressing
(See the following section.) selects a higher channel
number.)
Manually Tuning a Broadcast Station
If FM reception is not good
If reception is poor or much noise is heard, press YES/
MODE to turn off the AUTO indicator and switch to
monaural reception. In this way, you can reduce noise or
dropped signals. To return to AUTO tuning, press YES/
MODE again.
12
CD receiver
AUTOFM ST
SOURCE
SOURCE
Remote
YES/MODEcontroller
1Turn on the power to the CD receiver.
2Select FM or AM.
3Press or repeatedly while observing
the display to tune in the desired frequency.
Each press of the button changes the frequency by
0.05 MHz for FM and 9 kHz for AM. Pressing and
holding down the button for more than one second
will change the frequency continuously.
While FM is selected, pressing and holding or
down a while, then releasing it, will automati-
cally raise (or lower) the frequency.
When using the remote controller, press INPUT /
to select FM or AM, and press / to tune
in the desired frequency.
38 |
ACEC
