Control Position and Names
Rear Panel
For operational instructions, see the page indicated in brackets [ ].
AC INLET
IR
IN
OUT
VIDEO OUTPUT
COMPONENT
AUDIODIGITAL OUTPUT DVD CHANGER
PROUTPUTMODEL NO. DPC-5.3
VIDEOCOAXIAL OPTICAL
PBL
RS 232
YR
S VIDEO
1324 5 6 789
1 RS 232 port5 AUDIO OUTPUT jacks [14, 16]
This port is to be used in conjunction with an external controllerInsert audio cables (left and rights) to these jacks on your DVD
to control the operation of the DPC-5.3 using an external device.Changer and to the corresponding Audio Input jacks (left and
right) on your TV or receiver.
2 VIDEO OUTPUT COMPONENT (PR/PB/Y) jacks [15]
If your TV has component inputs, you can connect a component6 DIGITAL OUTPUT COAXIAL jack [16]
video cable to your TV and to your DVD Changer for idealUse coaxial cable to connect your DVD Changer to an AV
video quality. The component video cable only carries the videocomponent that features digital input capability. If the
signal; remember to connect the left and right audio cables.component has a Dobly Digital or DTS decoder, you can enjoy
If you connect a TV that is compatible with a Progressive scantheater-quality multichannel sound.
signal, you can enjoy both Interlaced and Progressive scan.
7 DIGITAL OUTPUT OPTICAL jack [16]
3 VIDEO OUTPUT S VIDEO jack [15]Use optical cable to connect your DVD Changer to an AV
If your TV has a S-Video jack, you can connect an S-Videocomponent that features digital input capability. If the
cable to your TV and to your DVD Changer for improved videocomponent has a Dobly Digital or DTS decoder, you can enjoy
quality. The S-Video cable only carries the video signal;theater-quality multichannel sound.
remember to connect the left and right audio cables.
8 IR IN/OUT jacks [37]
4 VIDEO OUTPUT VIDEO jack [14]If the DPC-5.3 is located inside a rack or cabinet that will not
Connect a video cable to this jack and to the Video Input jack onallow infrared beams to reach the IR sensor, you will need to
your TV.connect a remote sensor to IR IN jack to be able to use the
remote controller. Then install the remote sensor in an
unblocked location where you can easily point the remote
controller.
Using a mini-jack connector, connect IR emitter to the IR OUT
jack on the DPC-5.3 and then place the IR emitter on the remote
sensor of the component or facing it. Refer to page 37.
9 AC INLET [17]
Use to connect the power cord to the wall outlet.
11 |
ACEC
