Setting the Video 1 Options
Component Video Turning the Screen Saver On and Off Expert
Compared to a standard interlaced TV picture, a progressiveAs a protective function against residual images on the TV
scan TV is capable of stable, flicker-free images.screen or monitor, a phenomenon referred to as Oscreen burn�,
Set only if you connected the COMPONENT VIDEO OUT to athe screen saver appears when the same screen has been
progressive-scan compatible TV or monitor.displayed for a length of time. By default, the screen saver is
Make changes to the [Component Video] settings in the setupturned on. However, the screen saver function can be turned
screen [Video 1] menu.on and off at your discretion.
Make changes to the [Screen Saver] setting in the Setup
Audio1 A2 Video1 V2 Language General
screen [Video 1] menu in the [Expert] menu mode (page 47).
TV ScreenN16:9(Wide)
Component Video Progressive
Audio1 A2 Video1 V2 Language General
Video OutInterlace
S-Video Out S2TV ScreenN16:9(Wide)
Component VideoN Interlaced
Frame SearchNOff
S-Video OutN S2
Screen SaverNOff
Frame SearchOff
Screen SaverOn
MoveSETUPExit
Off
Y Progressive � Use this setting with TVs and monitors that haveMoveSETUPExit
progressive scan component video inputs. Check the TVOs
instruction manual if you are not sure about this.Settings: On
Y Interlace � (factory setting) use this setting with regular TVs thatOff (Factory setting)
are not compatible with progressive scan. Check the TVOs
Note
instruction manual if you are not sure about this.
Pressing 8 (or L ) displays a playback screen, and pressing 8
Notes(or L ) again resumes playback.
Y This function only works when the color system recorded on the
disc is NTSC.
Frame Search Expert
Y If this player is set to output progressive-scan video, itOs possible
that the picture will appear stretched when playing discs recordedSet this to [On] if you want to be able to do frame-accurate
in 4:3 format. This happens when the TVOs aspect ratio is setsearching of DVD discs. On the default setting, the time &
[Full]. To see the picture in its correct aspect ratio, change the TVframe search is not available.
setting to [Normal].
Y If your TV doesnOt have settings to change the aspect ratio of the
Audio1 A2 Video1 V2 Language General
picture, set this player to [16:9 (Compressed)].
TV ScreenN16:9(Wide)
Y If you connect a TV that is not compatible with a progressive scan
Component VideoN Interlace
signal and choose one of the progressive scan settings, you willS-Video OutN S2
not be able to see any picture at all. With your TV connectedFrame SearchOn
Screen SaverOff
using either the composite or S-Video terminals, choose the
[Interlace] settings in the [Component Video] menu.
MoveSETUPExit
Switching the S-Video Output ExpertSettings: On
Off (Factory setting)
You can switch the kind of S-Video signal output from the
S-Video outputs. If you connected your TV with an S-Video
cord, in rare cases the TV picture may appear stretched. In
this case switch the output from [S2] to [S1].
Make changes in the [S-Video Out] in the Setup screen [Video
1] menu in the [Expert] menu mode (page 47).
Audio1 A2 Video1 V2 Language General
TV ScreenN16:9(Wide)
Component VideoN Interlaced
S-Video Out S1
Frame SearchS2
Screen SaverN Off
MoveSETUPExit
Settings: S1
S2 (Factory Setting)
53
DPS8.3.E.46-64.p655302.9.12, 11:46 AM |
ACEC
