SEND/LEARN
indicator
MODE buttons
ENTER
Erasing the programmed commandErasing all the commands
from one buttonprogrammed under a MODE button
You can only erase memorized commands and not preset ones.
1Press and hold down the desired
Press and hold down the desiredMODE button, press the ENTER
1MODE button for the command,button twice, and then release both
press the ENTER button, and thenbuttons.
release both buttons.
When you press the MODE button, the
When you press the MODE button, theSEND/LEARN indicator lights. When you
SEND/LEARN indicator lights. When youpress the ENTER button, the lamp turns off.
press the ENTER button, the lamp turnsWhen you release the buttons, the lamp
off. When you release the buttons, theflashes twice slowly and then lights again.
lamp lights again.
Press and release the same MODE
2
Press and release the button for thebutton again.
2command you wish to erase.
When you release the button, the SEND/
When you press the button, the SEND/LEARN indicator flashes twice slowly. This
LEARN indicator turns off. When youerases all the commands memorized to the
release the button, the lamp lights again.MODE button.
Press and release the same button
3Notes
again.Y If no button is pressed for more than 30 seconds during the
The SEND/LEARN indicator flashes twiceerasing procedure, the SEND/LEARN indicator flashes three
slowly. The memorized command is erased.times quickly and the remote controller exits the erasing mode.
Resume from Step 1.
Y If you perform an invalid operation during erasing, the SEND/
NoteLEARN indicator flashes three times quickly, and the remote
If no button is pressed for more than 30 seconds during the erasingcontroller exits the erasing mode. Resume from Step 1.
procedure, the SEND/LEARN indicator flashes three times quickly, andY If many commands have been programmed to the MODE button,
the remote controller exits the erasing mode. Resume from Step 1.then the SEND/LEARN indicator may remain lit for up to 20
seconds during Step 2. This is not a malfunction.
83 |
ACEC
