Index Parts and FacilitiesNContinued
For further operational instructions, see the pages Inner panel
indicated in brackets [ ].
0Listening Mode button [61]
1Standby indicator [9, 52]Press this button to enter the setup mode for the
Lights when the DTR-10.5 is in the standby state listening mode. Turning the [Select/Preset] allows
and when a signal is received from the remote you to select the listening mode. To conŢrm your
controller.selection and exit the setup mode, press the [Select/
Preset].
2Standby/On button [52]
Press this button, the DTR-10.5 turns on and the AAudio Selector button [57]
display lights up. If pressed again, the DTR-10.5 Press this button to enter the audio selector mode.
returns to the standby state. In the standby state, the Turning the [Select/Preset] allows you to select the
display is turned off and the DTR-10.5 cannot be audio mode.
operated.BTone button [54]
3Remote control sensor [9]Press this button to enter the tone adjustment mode.
Turning the [Select/Preset] allows you to select the
4Display button [56]channel to adjust the tone. To adjust the tone level,
Press to display information about the current input
source signal. Each time you press the [Display] turn the [Control/Tuning].
CZone 2 button [68]
button, the screen changes to show you different
information concerning the input signal.Press this button to enter the Zone 2 conŢguration Getting Started
mode. Turning the [Select/Preset] allows you to
5Front display
select the input source for Zone 2. Also, if you want
6Input source buttons and indicators (DVD, to conŢgure other Zone 2 settings such as standby/
Video 1-7, Tape 1-2, Tuner, Phono, CD, and on setting, listening mode, volume adjustment,
Net Audio) [52]audio selector mode, and display settings, press this
Press these buttons to select the input source for the button Ţrst.
main zone.
DRec/Zone 3 button [68, 70]
After selecting the input source, the corresponding Press this button to enter the Rec/Zone 3 mode.
indicator turns blue. If you select Zone 2, the
indicator turns green. If you select Zone 3 or Rec, Turning the [Control/Tuning] allows you to select
the input source for the Rec mode or Zone 3. Also,
the indicator turns red.if you want to conŢgure the setting for Zone 3
7Master Volume dial [52]including standby/on setting or volume adjustment,
Use to control the volume in the main zone. The press this button Ţrst.
volume for the remote zone (Zone 2 and Zone 3) is
Note:
independent.Recording and Zone 3 operations uses the same
8Open buttoncircuit and therefore cannot be used at the same
Press this button to open the front panel door.time.
9Pure Audio indicatorEVideo 7 Input terminals [40]
Lights during pure audio playback.For connecting a video camera or game device.
FZone 3 Level button [68]
Press this button to enter the volume adjustment
mode for Zone 3. Turning the [Select/Preset] allows
you to adjust the volume.
GControl/Tuning dial
When the input source is FM or AM, turning this jog
dial allows you to select the frequency to receive.
When used with other buttons, this [Control/
Tuning] dial is used to select the mode settings or
values. Also the dial is pressed to conŢrm the
settings or values you select.
HSetup button [86]
Press this button to enter the setup mode. First,
select the parameter to change by turning the
[Select/Preset] and press the [Select/Preset] to
conŢrm the parameter. Then, change the parameter
value by turning the [Control/Tuning] and press the
[Control/Tuning] to conŢrm the value.
13 |
ACEC
