DV-L55_En.book Page 50 Friday, May 28, 2004 12:02PM
Troubleshooting
If you have any trouble using your DV-L55, check the following table for possible causes and remedies. If you still canOt
resolve the issue yourself, please contact your Onkyo dealer.
SymptomsCausesRemedies
Connect the power cord to a suitable wall outlet
The power cord is not connected.
(page 22).
CanOt turn on the Turn off the DV-L55, wait Ţve seconds, then try
DV-L55?External interference is affecting the turning it on again. If that fails, disconnect the
DV-L55Os digital circuitry.power cord from the wall outlet, wait Ţve seconds,
reconnect it, then try turning it on again.
Place the disc in the center of the disc tray
The disc tray wonOt The disc is not centered in the disc tray.
(page 25).
close properly?
The disc is dirty.Remove the disc and clean it (page 9).
No disc is loaded.Load a disc (page 25).
The disc cannot be played because itOs
Use only compatible discs (page 7).
incompatible.
The disc is upside down.Load the disc the correct way up (page 25).
Place the disc in the center of the disc tray
The disc is not centered in the disc tray.
(page 25).
CanOt start playback?
The disc is dirty.Remove the disc and clean it (page 9).
The disc uses parental lock and the Paren-
Turn off the Parental Lock function (page 43).
tal Lock function is on.
If the discOs region number does not match the
The DVD-Video disc is intended for use
region number printed on the rear panel of the
in another region.
DV-L55, the disc cannot be played (page 46).
The disc is dirty.Remove the disc and clean it (page 9).
The picture distorts
YouOre using the Fast Forward or Fast A little picture distortion may occur when using
occasionally?
Reverse function.these functions. This is normal.
The DV-L55 is connected to your TV via
Picture instability or a VCR or other video equipment and a Connect the DV-L55 directly to your TV
VD Playernoise?copy-protection system is affecting the (page 17).
D
picture.
The wrong input source is selected on On your TV, select the input to which the DV-L55
your TV.is connected.
Check the video cable and correct as necessary
The video cable is not connected properly.
(page 17).
No picture?
No video is output by the S-Video and composite
The video output is set to progressive video outputs while progressive scanning is
scanning.selected. If your TV doesnOt support progressive
scanning, select interlaced (page 18).
Before you disconnect the power cord, set the
If thereOs a power failure, or the power
DV-L55 to Standby by pressing the [STANDBY/
Settings are not saved?cord is disconnected inadvertently, any
ON] button, and wait until OGOOD BYE� has dis-
settings are lost.
appeared from the display.
The DV-L55 is connected to your TV via
a VCR or other video equipment and a Connect the DV-L55 directly to your TV
copy-protection system is affecting the (page 17).
picture.
Brightness is unstable
If you select progressive scanning while
or the picture is noisy?
using a TV that does not support it.
Your TV doesnOt support progressive
Switch the player to standby then, using the front
scanning.
panel controls, press STANDBY/ON while press-
ing to switch the player back to Interlace.
Chapters or tracks donOt
You are using repeat playback, program
play in the correct Select normal playback (pages 32�34).
playback, or random playback.
order?
50 |
ACEC
