00_DV-SP301.book Page 18 Friday, April 18, 2003 4:18 PM
Basic Playback
Before playing
Turn on the TV and set the TV to the DVD Player's input.Warning
Turn on the audio system and set it to the DVD Player?s input, if an audio If the DVD Player is connected to the TV or amplifier
system is connected to the DVD Player.through the analog audio jacks, do not play DTS-
DVD-Video, Video CD, CD, MP3, WMA, JPEG can be played with the encoded discs. Excessive noise may be output from the
DVD Player (see ?Notes on Discs? on page 6 and 7). Do not play analog stereo jacks, which may damage the connected
anything else.equipment.
About the marks in the pages related to disc operationTo reproduce DTS surround sounds, digital connection
DVD means the function or title is related to DVD-Video operation.to an amplifier with a DTS decoder is needed.
VCD means the function or title is related to Video CD operation.
CD means the function or title is related to audio CD operation.
MP3 means the function or title is related to MP3/WMA sound operation.
Both MP3 and WMA are referred to as MP3 in the following pages.
JPEG means the function or title is related to JPEG image operation.
DVDVCDCDMP3JPEG
Starting Playback
Disc trayOPEN/CLOSESTOPPLAY/PAUSE
SKIPSEARCH
1Press OPEN/CLOSE 0. To stop playback
The disc tray opens. If the DVD Player is in standby mode Press STOP 7.
when the OPEN/CLOSE 0 button is pressed, the DVD When you press PLAY/PAUSE L/8 to restart playback,
Player turns on and the disc tray opens. In this case, it takes playback starts from the location where you stopped playback
several seconds until the disc tray opens.because the location index is stored in memory.
For JPEG image playback, see page 21.
2Place a disc on the disc tray.Notes
The location where playback resumes may vary depending on
Put the disc in the tray with the label side facing up.There
are two different disc sizes. Place the disc in the correct the disc or the scene where you stopped.
guide on the disc tray.Press STOP 7 again after stopping playback to clear the
location index memory, then press PLAY/PAUSE L/8 to start
playback.
3Press PLAY/PAUSE L/8.
The disc tray closes and playback starts. The appropriate
disc indicator lights. To remove the disc
The disc indicator does not light up for CDs that contain Press OPEN/CLOSE 0 to open the disc tray.
JPEG images. For the other information that appears in the Remove the disc after the disc tray opens completely.
display, see page 11. After removing the disc, be sure to press the button again to close
If the DVD Player is in standby mode when PLAY/PAUSE the tray.
L/8 is pressed, the DVD Player turns on and playback
starts. In this case, it takes several seconds until playback CAUTION
starts.Keep your fingers well clear of the disc tray as it is closing.
Neglecting to do so may cause serious personal injury.
Tip to obtain a higher quality picture
Occasionally, some picture noise not usually visible during a
normal broadcast may appear on the TV screen while playing a
DVD-Video because the high resolution pictures on these discs
include a lot of information. While the amount of noise depends
on the TV you use, you should generally adjust the TV to reduce
sharpness when viewing DVD-Videos.
18 |
ACEC
