%9$@&OCPPL 1BHF .POEBZ
4FQUFNCFS
1.
Troubleshooting
If you have any trouble using your DX-C34, check the following table for possible causes and remedies. If you still can�t
resolve the issue yourself, please contact your Onkyo dealer.
TroublePossible CauseRemedy
Properly connect the power cord to the DX-C34�s
No power.The power cord is not connected properly.AC INLET and connect the other end to a suitable
wall outlet (page 14).
There are no batteries in the remote controller. Install new batteries (page 10).
The batteries are �at.Replace with new batteries (page 10).
Check the batteries and correct as necessary
The batteries are installed incorrectly.
(page 10).
You�re not pointing the remote controller at the Point the remote controller at the DX-C34�s
DX-C34�s remote sensor.remote sensor (page 10).
The remote controller does Use the remote controller closer to the DX-C34
not work.You�re too far away from the DX-C34.(page 10). The remote controller has a range of
approximately 5 meters (16 ft.).
Make sure that the DX-C34 is not subjected to
A strong light source is interfering with the
direct sunshine or inverter-type �uorescent lights.
DX-C34�s remote sensor.
Relocate if necessary.
If the DX-C34 is installed in a cabinet with col-
Open the doors, or use a cabinet without colored
ored glass doors, the remote controller may not
glass.
work reliably when the doors are closed.
Load the disc with the label-side facing up
The disc is upside down.
(page 14).
The disc is dirty.Remove the disc and clean it (page 27).
Cannot play a CD.Remove your discs and leave the DX-C34 turned
Condensation has formed inside the DX-C34.on for several hours until the condensation has
evaporated.
The CD-R/RW disc is nonstandard.See �Disc Notes� on page 26.
The DX-C34 is not connected properly.Check all connections and correct as necessary.
There is no sound.The wrong input source is selected on your Check your amp�s input source setting. Refer to
amp.your amp�s manual.
The DX-C34 is subject to vibration.Install the DX-C34 somewhere free of vibration.
CD playback skips.The disc is dirty.Remove the disc and clean it (page 27).
The disc is very scratched.Buy a new disc.
No disc is loaded.Load a disc (page 14).
Cannot enter track num-
The track number entered doesn�t exist on the
bers for memory playback.Enter the correct track number (page 18).
disc.
It takes a long time to The disc is dirty.Remove the disc and clean it (page 27).
locate certain tracks.The disc is very scratched.Buy a new disc.
To use you must make an analog audio con-
There�s no RCA/phono analog audio connec-nection (RCA/phono) between the DX-C34 and
does not work.tion.your Onkyo AV receiver, even if they are con-
nected digitally.
The digital outputs do not The sampling rate of the currently playing MP3 Select a track with a sampling rate of 32 kHz,
work.track is not 32 kHz, 44.1 kHz, or 48 kHz.44.1 kHz, or 48 kHz.
Abnormal Behavior
The DX-C34 contains a microcomputer for signal processing and control functions. In very rare situations, severe
interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this
should happen, unplug the power cord from the wall outlet, wait at least Ţve seconds, and then plug it back in again.
25 |
ACEC
