System Connections
?Do not plug in the power cord until all connections have been made.
?On each pair of input or output jacks, the jack marked R corresponds to the right channel and the jack marthe leftked L corresponds to
channel.
WARNINGAVIS
RISK OF ELECTRIC SHOCKDO NOT OPENRISQUE DE CHOC ELECTRIQUENE PAS OUVRIRCOMPACT DISC PLAYERMODEL NO. DX-C380
OUTPUTREMOTED IG I TALOUTPUTOPTICAL
CONTROL
L
R
To wall
Audio
outlet
connection
cableOptical fiber cable
cable(not included)
LR
CDOptical IN
DAT, MD recorder or
Amplifier
Digital amplifier
Connecting to an audio systemConnections for remote controller ()
Two types of output jacks are located on the rear panel.When connecting Onkyo products, it is necessary to attach the
Use the DIGITAL OUTPUT jack if you are connecting the unit tocable to be able to use the remote controller of the main component
audio equipment that supports a digital connection.to control the entire system.
OUTPUT (analog) jacks:1. To use this CD changer with an amplifier (or receiver), cassette
These are the most commonly used jacks. Connect these jacks to thetape deck, and tuner that include the appropriate jack, con-
nect the components using the cable, plugged into the RE-
amplifierOs CD input jacks using the supplied audio connection cable.
MOTE CONTROL jacks.
DIGITAL OUTPUT (optical) jack:
2. As the exact connection sequence of the cable is unimpor-
For digital recording, connect this jack to the digital input jack of a
tant, you can connect from the amplifier (or receiver) to either the
Mini Disc recorder, a DAT deck, or other digital equipment. If your
tuner, cassette tape deck, or compact disc changer.
amplifier has a digital input jack, connecting the DIGITAL OUT-
3. To operate correctly, the remote controller must point toward the
PUT jack to it will produce a much clearer and more dynamic sound.
remote control sensor of the amplifier (or receiver).
?Terminal protection cap is attached to the digital jack.
NOTES:
Remove the cap when connecting the unit to other digital equip-
?The upper and low REMOer TE CONTROL jacks have the
ment. When you are not using the digital output jack, replace the
same function.
cap.
?Remote controller operation is not possible when only the
?Refer to the amplifierOs instruction manual for connections.
cable is connected � the audio connection cables must also be
connected.
?An cable equipped with a 3.5mm (1/8 in.) diameter minia-
ture two-conductor phone plug is included with this unit and with
every tuner and cassette tape deck that utilizes the jack.
Connecting the power
1122
Before plugging in the unit, confirm that all
POWERconnections have been made properly.
NEXT SELECTIONOPEN/CLOSEPAUSESTOPPLAY
POWERDISPLAY1.1.Insert the AC power supply cord into
ON MEMORYCLEARDISC SKIPDISC 1DISC 2DISC 3DISC 4DISC 5DISC 6 OFF
FIVE CD EXCHANGE CONTINUOUS PLAY6 DISCTo AC outletthe outlet.
COMPACT DISC CHANGERDX-C5402.2.Press the POWER button.
ON OFF
?When the power first turns on, the carou-
sel rotates to find a disc and stops auto-
matically if there is a disc on the disc tray.
7 |
ACEC
