RECORDING� Audio dubbing �
Memo
Connection
Y During audio dubbing, if the tape comes to a part
Audio dubbing sounds are input from the AUDIO IN
recorded in a non dubbing-feasible mode (such
terminal on the rear panel or the MIC terminal on
as LP mode or 48kHz audio mode), the VTR will
the front panel. MIC terminal prevail over the AU-
enter the STOP mode. When this happens, high-
DIO IN terminal.
volume noise from the DV output will occur.
Hence, before audio-dubbing, please check the
Setting
recording mode of the tape.
Y Set the AUDIO item of the AUDIO/VIDEO menuY In the case that a microphone is connected to
to O32K�.the MIC terminal, sound output from this termi-
Y Do not set the INPUT switch on the front panel tonal will be recorded. In the absence of MIC input,
ODV�.signals from the CH1/3, CH2/4 AUDIO IN termi-
nal on the rear panel will be recorded.
Operation
Y When audio dubbing cannot be performed, an
alarm message will be displayed on the monitor.
1.Press the PLAY button to play the tape.( Page 23)
2.At the position where you want to au-Y Audio dubbing PAUSE cannot be executed di-
dio dub, press the PAUSE button.rectly in the STOP mode. Please execute it in the
STILL mode.
Y The unit goes into the STILL mode.
During audio dubbing pause, sound from the
3.Hold down the A.DUB button and pressCH3/CH4 channel is output via the monitor but
the PAUSE button.
sound output from the DV terminal is not pos-
Y The unit goes into the audio dubbing pausesible.
mode.
Y If audio dubbing is repeated on a short section of
the tape, noise may occur for an instant when
4.Press the PAUSE button.
the section is played.
Y Audio dubbing begins. Audio signals are
Y During audio dubbing, noise may be produced
recorded on the CH3 and CH4 channel.
on the playback video or playback sound but the
recording is normal.
To stop audio dubbing temporarily, press
the PAUSE button.Y The playback sound of CH1/2 cannot be recorded
on CH3/4 (sound on sound).
5.To end audio dubbing, press the STOPY During backspace operation of audio dubbing,
button.audio dubbing cannot be performed on unre-
corded parts.
Y When audio dubbing is performed on tapes re-
corded on other devices, it may not record cor-
rectly. Please record with this unit before perform-
ing audio dubbing.
E-40 |
ACEC
