Menu configuration (cont.)
RECORDING SETUP screen
Item/Item/
(DisplayDescription of settings(DisplayDescription of settings
mode)mode)
TCGUse this to set the mode in which toUB MODEUse this to set what is to be recorded as
(CAMERA)advance the time code.(CAMERA)the userOs bit.
(VCR)FREE RUN:(VCR)USER:
The time code is advanced continuouslyThe userOs information is recorded.
regardless of the operation mode.TIME:
It is recorded on the basis of the timeThe recording time is recorded.
appearing on the camera-recorderOsDATE:
calendar clock.The recording date is recorded.
REC RUN:TCG:
The time code is advanced only whenThe time code is recorded.
recording is underway.UB PRESETUse this to set the userOs bit.
It is recorded while ensuring that(CAMERA)For this, however, OUSER� must have been
continuity is maintained with the time
code already recorded on the tape when(VCR)selected as the UB MODE item setting.
shooting with frame-to-frame continuity.ONE-SHOTUse the ON setting when shooting on a
RECframe-by-frame basis.
FIRST REC TCUse this to select the time code to be
(CAMERA)recorded when recording is started.(CAMERA)OFF:
(VCR)REGEN:Frame-by-frame shooting is not
Select this to record the time code thatperformed.
ON:
will ensure continuity with the time codeThe camera-recorder is set to the frame-
already on the tape.by-frame shooting mode.
The time code is recorded in the RECWhen the START/STOP button is
RUN mode regardless of the settingpressed, recording proceeds for the
selected for the TCG item.
PRESET:number of seconds selected by the REC
Select this to record the time code usingTIME item setting, and then the camera-
recorder is set to the REC PAUSE
the value selected by the TC PRESETmode.
item as the initial value.
However, when shooting with frame-to-REC TIMEUse this to set the recording time for frame-
frame continuity has taken place, the(CAMERA)by-frame shooting.
time code is recorded to ensure0.5s : 0.5 sec.1s : 1.0 sec.
continuity with the time code already on1.5s : 1.5 sec.2s : 2.0 sec.
the tape.
TC PRESETUse this to set the initial value of the time
(CAMERA)code to be recorded.
(VCR)The item takes effect when OPRESET� has
been selected as the FIRST REC TC item
setting.
1394 UBUse this to select the userOs bit to be
REGENrecorded when recording the signals of the
(VCR)unit connected to the DV connector.
OFF:
The userOs bit selected by the UB MODE
item is recorded.
ON:
The userOs bit of the signals input to theMENUS
DV connector is recorded.
O When OON� has been selected as this
itemOs setting, it takes precedence over
the UB MODE item setting.
O If the signals do not contain the userOs bit
information, the userOs bit is not
recorded.
O If no signals are input to the DV
connector, the UB MODE item setting is
used for the recording.
The underlining indicates the factory setting.
77 |
ACEC
